Bedienungsanleitung Gorenje VC1601BUWD (Seite 24 von 61) (Englisch, Polnisch)

729219

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

•

When using the vacuum cleaner for

several consecutive hours, fully

unwind the power cord.

•

In case of a liquid leak, immediately

switch off the appliance and unplug

the power cord.

•

Protect the vacuum cleaner from

rain. Do not store it outdoors. Keep

the appliance in dry places indoors.

Store the appliance after use.

•

The appliance complies with the

effective German and European

standards regarding electricity and

radio interference regulations.

•

Noise level: Lc < 76 dB (A)

Connecting to the power

mains

Make sure the voltage data specified on the

rating plate correspond to the voltage in your

power mains.

Power cord

If the power cord is damaged, replace it with a

suitable cord or a cord winding device/assembly

sourced from the nearest Gorenje service centre.

If the power cord is damaged, it may only be

replaced by Gorenje, Gorenje's authorized

service and repair centre, or an adequately

trained professional.

Compliance with the

European standards

A test of this appliance has confirmed

compliance with the following European

directives:

• 2014/35/EU

• 2014/30/EU

• 2009/125/EC

• 2011/65/EU

This equipment is labelled in compliance with

the European Directive 2012/19/EC on waste

electric and electronic equipment – WEEE.

The Directive specifies the requirements for

collection and management of waste electric

and electronic equipment effective in the

entire European Union.

Appliance disposal and the

environment

If you find you wish to replace your appliance or

that you no longer need it, consider the

environment and ways to protect it.

Start-up and operation

Before attaching or removing the attachments,

always unplug the power cord from the power

outlet. Before switching on the appliance, make

sure all filters are correctly installed.

ASSEMBLY

• Remove the appliance upper part (motor

housing) and remove the accessories from

the container. (Figure 1)

• Attach the wheels to the bottom of the

vacuum cleaner. (Figure 2)

• Place the appliance upper part (motor

housing) over the container and close the

snap locks. (Figure 3)

• Connecting the attachments. Connect the

flexible hose to the suction port and rotate it

in the "CLOSE" direction. (Figure 4)

• Assemble the two-part tube and connect the

floor brush. (Figure 5)

• Plug in the power cord and switch on the

appliance. (Figure 6)

DRY VACUUM CLEANING

Note: Always use a filter bag when vacuum

cleaning fine dust. Make sure the container is dry

and that the microfilter bag is correctly in place.

• Use the universal floor brush.

• How quickly the microfilter bag will fill up

depends on the dirt you are vacuum

cleaning.

• When vacuum cleaning fine dust, sand etc.,

the bag should be replaced more frequently.

• Change the bag more frequently to prevent

it from tearing.

WET VACUUM CLEANING

Note: Never use a bag.

• To vacuum clean liquids, use the liquid

suction attachment. (Figure 7)

• If the container is full, the float will

automatically close the suction port. The

appliance will have no suction power and it

will operate at a higher rpm rate.

Immediately switch off the appliance and

empty the container.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje VC1601BUWD Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info