729278
21
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
21
putting the appliance into service, please check if
all filters are inserted correctly.
ASSEMBLY OF THE SUCTION HOSE
Insert the flexible suction hose into the
connection opening at the top of the
housing until you can feel it lock.
HOSE REMOVING
To remove flexible hose from the vacuum
cleaner, press the buttons situated on the
flexible hose base, then pull to remove it
from the attachment point.
ROLLING THE CABLE OUT AND UP
Pull out the cable to such a length that easy
working is ensured. Now connect the
appliance to the main supply. Press the
switch to activate the automatic rewinder
and hold on the mains plug for safety
reason.
FITTING TUBE AND ACCESSORIES
- Extend the tube to the desired length by
pressing on button.
- Insert a flexible hose into a tube.
- Fit a nozzle to tube:
- Floor brush is intended for cleaning
bare floor and floor coverings.
- 3 pcs. set of nozzles are appropriate
for cleaning corners and other small,
inaccessible places.
- Carpet brush is appropriate for
cleaning carpets, carpetings and other
similar surfaces.
Instruction for use
Before using the appliance, unwind a
sufficient length of cord and insert the plug
into the power supply.
Press the On/Off button to switch the unit
on. To stop it press the On/Off button again.
You can adjust the air flow using the air flow
regulator on the flexible hose:
- decrease power for cleaning curtains,
books, furniture, etc.
- increase power for cleaning bare floor.
To rewind the cord, press the rewind button and
guide the cord with hand to ensure that it does
not whip causing damage.
Maintenance
1. Changing of the dust bag
Always operate the cleaner with dust bag
installed.
If you forget to attach the dust bag or attach
it in the wrong manner, the dust cover may
not close completely.
1. After removing the flexible tube, open the
front cover.
2. Rotate the support of the bag to the correct
position.
3. Remove the dust bag.
4. Replace the bag when it is full of dirt and
put in a new one.
5. Close the cover by passing down unitil it is
locked.
2. Cleaning filter
1. Open the cover for HEPA filter.
2. When open the cover for HEPA filter, use
your two fingers pulling ouch for HEPA,
then pulling HEPA up.
3. Take the HEPA out and change a clean
one.
4. Close the cover for HEPA filter.
Care and cleaning
Switch off the appliance and pull out the plug
from the power supply.
21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gorenje VCEA23GPRBU wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info