Bedienungsanleitung Gorenje wt 841 (Seite 3 von 8) (Englisch)

303351

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

Instructions for Use

Vent pipe can be bought in any technical store

(identification code PIPE SP-377628).

B - Condenser - type Dryer

Do not install the condenser dryer into the room

where a danger of freezing can occur. Freezing

of water in the condensed water drawer and the

pump can damage the appliance.

Positioning

This dryer is a self standing appliance and can

stand alone, or it can be placed either together

with a washing machine or in the kitchen as a

kitchen unit.

If the floor is uneven, use the adjustable feet to

level the machine.

Undo the nuts. Rotate the feet to level the

machine (fig. 3).

Lock the nuts (fig. 3a).

x Do not remove the adjustable feet. The

machine must be placed horizontally.

x Some models of tumble dryers are supplied

with vacuum leg braces, enabling the appliance

to be placed on top of a washing machine,

without hazard of falling or tripping during the

operation of either appliance.

x Do not put the dryer on the thicker rug thus

preventing the possibility of air circulation.

Moist Air Outlet

A – Vent dryer

There are two openings for venting out humid air,

which are situated at the bottom left-hand rear

side part of the dryer. Depending on the position

of the machine, please, close down one of the

openings with the front cover, which has already

been fastened on it, or attached to the drum (Fig

4).

Fix the cover by inserting a coin into the slash

turning it clockwise. It can be removed by turning

in the opposite direction.

If during the drying cycle the airing is not good

enough, the air-vent tube can be inserted

(screwed) into the hole. The distance between

the dryer and venting opening (airduct or window)

must not exceed two meters, otherwise

condense can accumulate in the tube, (Fig 5,6).

1 Decorative cap

2 Vent pipe

B – Condenser - type Dryer

Humidity from the laundry in the condenser dryer

is extracted into the air cooler and accumulated in

the drainage container or conducted directly into

the moist air outlet. After every drying the

condensed water drawer should be emptied, of

which you are reminded by the control lamp

which is on when the container is full. The air

cooler should be cleaned in time (see the chapter

Maintenance and Cleaning)

Channelling the condenser tube to the drain

outlet

Take off the condensed water drawer tube from

the rear side of the dryer and by fitting an elbow

on it channel the tube into the drain outlet. Height

of the drain must not exceed 800 mm.

Connecting to Power Supply

The appliance is connected to the power supply

by means of a cable cord plug. The wall socket

should be earthed (safety socket). Required

nominal current and frequency are stated on the

rating plate. The wiring should withstand

maximum load. Electric connection and earthing

should be carried out in accordance with current

standards and regulations.

IMPORTANT

In the supply cord is damaged, it must be

replaced by the manufacturer or his service agent

or a qualified person in order to avoid hazard.

x The appliance should be placed in the position,

where the plug is within reach.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gorenje wt 841 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info