590625
28
Zoom out
Zoom in
Vorherige Seite
1/74
Nächste Seite
28 GMC-I Messtechnik GmbH
V/Hz, Ω, Temperature, and A/Hz Measurements
5 Measurements
5.1 Voltage Measurement
Notes Regarding Voltage Measurement
The multimeter may only be operated with installed batteries or re-
chargeable batteries. Dangerous voltages are otherwise not indi-
cated, and the instrument may be damaged.
The multimeter may only be operated by persons who are ca-
pable of recognizing contact hazards and taking the appropriate
safety precautions. Contact hazards exist anywhere, where
voltages of greater than 33 V (RMS) may occur. The test
probes may only be gripped up to the finger guard. Do not
touch the metallic test probes under any circumstances.
Avoid working alone when taking measurements which involve
touch hazards. Be certain that a second person is present.
For the METRAHIT ULTRA, maximum allowable voltage between the
connector sockets and ground is 600 V for measuring cate-
gory III and 300 V for measuring category IV.
Be prepared for the occurrence of unexpected voltages at de-
vices under test (e.g. defective devices). For example, capaci-
tors may be dangerously charged.
No measurements may be made with this instrument in electri-
cal circuits with corona discharge (high-voltage).
Special care is required when measurements are made in HF
electrical circuits. Dangerous pulsating voltages may be pres-
ent.
Be aware of the fact that dangerous voltage spikes are not displayed
during measurement with the low-pass filter. We recommend mea-
suring voltage without the low-pass filter first, in order to be able to
detect any dangerous voltages.
Be absolutely certain that the measuring ranges are not over-
loaded beyond their allowable capacities. Limit values are included
in section 8, “Technical Data”, in the table entitled “Measuring
Functions and Measuring Ranges” in the “Overload Capacity”
column.
300 mV range: Thermovoltages occur in the event of tempera-
ture fluctuation, which appear as additional voltage offset. It
may be necessary to repeat zero offsetting in order to achieve
the specified degree of accuracy.
Scope of Functions, Voltage Measurement
1
A 1 kHz low-pass filter can be used in this case, in order to filter out high
frequency pulses of greater than 1 kHz, for example when performing
measurements at pulsed motor drives.
Function
METRAHIT ULTRA
V AC / Hz TRMS, dB (Ri = 5 MΩ)
1
V AC / TP-Filter 1 kHz
1)
(Ri = 5 MΩ) TRMS
V AC+DC TRMS / TP-Filter (Ri =5 MΩ)
V DC (Ri = 10 MΩ)
Pulse frequency, MHz @ 5 V TTL
Duty cycle as %
Voltage level measurement, dB @ V
AC
@ V
AC+DC
Frequency bandwidth
100 kHz
28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gossen Metrawatt METRAHIT ULTRA BT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info