Bedienungsanleitung Gossen Metrawatt Profitest Intro (Seite 8 von 62) (Englisch)

776259

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

8GMC-I Messtechnik GmbH

4 Initial Start-Up

4.1 Installing or Replacing the Battery Pack

Attention!

Before opening the battery compartment, disconnect the

instrument from the measuring circuit (mains) at all poles!

Note

See also section 18.2 on page 52 regarding the charging

procedure for the Compact Master Battery Pack (Z502H)

and concerning the Z502R charger.

If at all possible, use the Compact Master Battery Pack (Z502H) with

sealed cells which is available as an accessory. This ensures that the

complete set of rechargeable batteries is always replaced at the

same time and that all batteries are inserted with correct polarity,

in order to assure that they do not fail.

Only use commercially available rechargeable battery packs if they will

be externally recharged. The quality of these packs cannot be

checked and may result in overheating and thus deformation

under unfavorable conditions (when charging them in the instru-

ment).

Dispose of rechargeable battery packs or individual rechargeable

batteries in an environmentally sound fashion when their service

life has nearly expired (approx. 80% charging capacity).

➭Loosen the slotted screw for the rechargeable battery com-

partment lid on the back and remove the lid.

➭Remove the depleted rechargeable battery pack/holder.

Attention!

If the rechargeable battery holder is used:

Make sure that all of the batteries are inserted with cor-

rect polarity. If just one battery is inserted with reversed

polarity, it will not be recognized by the instrument and

may result in leakage from the batteries.

Individual rechargeable batteries may only be recharged

externally.

➭Insert the new rechargeable battery pack / loaded recharge-

able battery holder into the rechargeable battery compart-

ment.

The holder can only be inserted in its proper position.

➭Replace the lid and retighten the screw.

4.2 Switching the Instrument On/Off

The test instrument is switched on by pressing the ON/START key.

The menu which corresponds to the momentary selector switch

position is displayed.

The instrument can be switched off manually by simultaneously

pressing the MEM and HELP keys.

After the period of time selected in the SETUP menus has elapsed,

the instrument is switched off automatically (see “Device Set-

tings”, section 4.5).

4.3 (Rechargeable) Battery Test

If (rechargeable) battery voltage has fallen below the

allowable lower limit, the pictograph shown at the

right appears. “Low Batt!!!” is also displayed along with a

(rechargeable) battery symbol. The instrument does not function if

the batteries have been depleted excessively, and no display

appears.

4.4 Charging the Battery Pack in the Tester

Attention!

Use the Z502R charger in order to recharge the Compact

Master Battery Pack (Z502H) in the test instrument.

Make sure that the following conditions have been fulfilled be-

fore connecting the charger to the charging socket:

– The Compact Master Battery Pack (Z502H) has been

inserted, i.e. not a commercially available rechargeable

battery pack, individual batteries or non-rechargeable

batteries.

– The test instrument has been disconnected from the

measuring circuit at all poles.

– The instrument must remain off during charging.

Refer to section 18.2.1 with regard to charging a rechargeable

battery pack which has been inserted into the tester.

If the rechargeable batteries or battery pack have not been used

or recharged for a lengthy period of time (> 1 month), thus result-

ing in excessive depletion:

Observe the charging sequence (indicated by LEDs at the char-

ger) and initiate a second charging sequence if necessary (dis-

connect the charger from the mains and from the test instrument

to this end, and then reconnect it).

Please note that the system clock stops in this case and must be

set to the correct time after the instrument has been restarted.

BAT

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gossen Metrawatt Profitest Intro Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info