Bedienungsanleitung Graco Booster Basic (Seite 15 von 100) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

768340

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

FAILURE TO USE booster seat in a manner appropriate for your

child’s size may increase the risk of serious injury or death.

Weight and Height Limits

To use this Graco booster seat, your child MUST meet ALL of the

following requirements:

With back support (approximately 3 to 12 years old) :

• weigh between 15-36 kg, and

• are between 96 and 150 cm in height, and

• the shoulder belt MUST lay across child’s shoulders in red zone as shown

in 12 and the lap portion is positioned low on the childs hips, and

• the child’s ears are below top of booster seat. If tops of ears are above top

of seat, your child is too large for the booster seat

Without back support (approximately 4 to 12 years old) :

• weigh between 15-36 kg, and

• are between 101 and 150 cm in height, and

• the shoulder belt MUST lay across child’s shoulders in red zone as shown

in 13 and the lap portion is positioned low on the childs hips, and

• when sitting on the booster seat, your child’s ears are below the top of the

vehicle seat cushion / head rest.

Your Graco booster seat can be used with or without the back support (on

certain models) as long as the above requirements are met.

UNSAFE Vehicle Seat Belt Systems

DO NOT USE ANY OF THE FOLLOWING VEHICLE BELT

SYSTEMS.

• NEVER use a lap-only belt.

• NEVER use a Passive Restraint Lap or Shoulder Belt Mounted on

Door

Assembling the booster seat

To adjust armrests, remove screw and press in button on side of base as

shown to raise or lower. Reinsert screw and tighten. CHECK to make

sure armrests are securely attached by pulling up on them.

Slip armrest covers (on certain models) onto armrests as shown.

Your Graco booster seat is now ready to use. See “Securing Child in

Vehicle with Shoulder Belt Positioning Clip”.

FOR MODELS with a back support continue on to 5.

Flip head support and lower back support over as shown.

Squeeze red adjustment button and slide two pieces together until they

snap into place.

CHECK to make sure two pieces are securely snapped together by pulling

on them.

Attach elastic strap as shown.

Flip seat over and insert the fabric from the head support underneath the

fabric on the lower back support as shown.

To make insertion of fabric easier, slide the upper and lower back pieces

apart by squeezing the red adjustment button.

Attach backrest to base. “U”-shaped hooks on bottom of backrest will

interlock with bars on base.

Make sure that no part of the seat covering interferes when attaching

backrest to the base.

Once backrest is securely attached to the base, push backrest up as shown.

Your Graco booster seat is now ready to use. See “Using your Graco

Booster Seat” and “Securing Your Child in Vehicle”.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Graco Booster Basic Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info