Bedienungsanleitung Graco SlimFit LX (Seite 8 von 47) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

768343

Zoom out

Zoom in

Vorherige Seite

1/47

Nächste Seite

13 14

Weight Guidelines

Rear-Facing with 5- Point Harness

0-9 kg MUST be rear-facing.

9-18 kg CAN be rear-facing.

Using 3-point belt only

Forward- Facing with 5- Point Harness

9-18 kg CAN be forward-facing with harness.

Installation using ISOcatch System and 3-point belt or using

3-point belt only (Please do not install using ISOcatch System only)

Booster Mode with Vehicle Lap/Shoulder Seat Belt

15-18 kg CAN be in booster mode.

Over 18 kg MUST be in booster mode.

Installation using ISOcatch System and 3-point belt or using

3-point belt only (Please do not install using ISOcatch System only)

For Installation with 3-point-belt

1. This is a ‘Universal’ child restraint. It is approved to UN ECE

regulation 44, 04 series of amendments, for general use in

vehicles and it will ﬁt most, but not all car seat.

2. A correct ﬁt is likely if the vehicle manufacturer has declared

in the vehicle handbook that the vehicle is capable of

accepting a ‘Universal’ child restraint for this age group.

3. This child restraint has been classied as ‘Universal’ under more

stringent conditions than those which applied to earlier

designs which do not carry this notice.

4. If in doubt, consult either the child restraint manufacturer or

the retailer.

For Installation with ISOcatch System

and 3-point-belt

1. The child restraint is classiﬁed for “Semi-Universal” use.

2. It is suitable for ﬁxing into the seat positions (Please refer to

our vehicle ﬁtting list).

3. Seat positions in other cars may also be suitable to accept the

child restraint. If in doubt, consult either the child restraint

manufacturer or vehicle manufacturer.

Rear-Facing Seat :

Group 0+ /1 (0-18 kg) 

Child restraint system must be rear-facing in the vehicle seat.

Make sure vehicle seat belt is routed through the rear-facing

belt path marked with a blue label.

Install this child restraint system tightly in your vehicle.

Harness straps must be at or just below the top of child’s

shoulders.

Infants who weigh less than 9 kg MUST be rear-facing.

Install Rear-Facing With Vehicle Seat Belt

 Recline the child restraint system-

Place the child restraint system in recline position 1 or 2.

 Place child restraint system Rear-Facing in the Vehicle-

Place the base flat on the vehicle seat. Push it back until the

front of the child restraint system touches the vehicle seat

back.

 Route the Vehicle Seat Belt-

A Unsnap the pad from back and pull lower seat pad forward to

expose the plastic shell.

B Thread vehicle lap seat belt through the rear-facing belt path

(marked with a blue label) and buckle it. The seat belt should

lay as flat as possible and not be twisted. Make sure buckle

and seat belt are in line with each other. Contact Graco if in

doubt about this point. Replace the seat pad.

 Thread the shoulder belt through the rear-facing shoulder

belt guide on the back of the seat marked with blue labels.

The seat belt should lay as flat as possible and not be twisted.

 Tighten the Vehicle Seat Belt-

Press down firmly in the center of the child restraint system.

Pull on the shoulder belt to tighten while feeding the slack

back in the retractor.

Forward-Facing Seat:

Group 1 (9-18 kg) 

Installation using ISOcatch System and 3-point belt or using

3-point belt only

Child restraint system must be forward-facing in the vehicle

seat.

Make sure vehicle seat belt is routed through the forward-

facing belt path marked with a bright red label.

Install this child restraint system tightly in your vehicle.

Harness straps must be at or just above the child’s shoulders.

Install Forward-Facing With

ISOcatch System

If vehicle is equipped with ISOFIX, the vehicle lower

anchor points may be visible at the vehicle seat crease. See

your vehicle owner’s manual for exact locations, anchor

identification, and requirements for use.

 Fit the ISOcatch guides with the ISOFIX anchor points. The

ISOcatch guides can protect the surface of the vehicle

seat from being torn. They can also guide the ISOcatch

connectors.

 Press the ISOcatch adjusting button to pull out the ISOcatch

connectors.

 Rotate the ISOcatch connectors by 180 degrees until they are

pointing in the direction of the ISOcatch guides.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Graco SlimFit LX Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info