Bedienungsanleitung Gram FS 120-II (Seite 21 von 32) (Englisch, Holländisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

460584

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

If two freezers or a freezer and a refrigerator are

placed side by side, there must be at least 2 cm

clearance between them.

If the appliance is not built in but positioned with

its door hinge side against a wall, there should be

at least 5 cm between the appliance and the wall

in order to allow the door to open easily.

The freezer must not be laid horizontally while

being transported or moved. If the appliance has

been tilted more than 40°, the power supply must

not be connected until the appliance has stood

upright for at least two hours.

The appliance is intended for connection to alter-

nating current. The connection values for voltage

(V) and frequency (Hz) are given on the nameplate

in the cabinet.

Power must be connected via a wall socket with

switch. The wall socket should be easily acces-

sible.

All earthing requirements stipulated by the local

electricity authority must be observed. The appli-

ance plug and wall socket should then give correct

earthing. If in doubt, contact your local supplier or

an authorised electrician.

WARNING

The exible cord (mains lead) tted to this appliance

has three cores for use with a 3-pin 13-amp or 3-pin

15-amp plug. If a BS 1363 (13-amp) fused plug is

used, it should be tted with a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in ac-

cordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug.

Proceed as follows:

Connect the GREEN-AND-YELLOW core to the

plug terminal marked “E” or by an earth symbol, or

coloured GREEN or GREEN-AND-YELLOW. Con-

nect the BLUE core to the plug terminal marked “N”

or coloured BLACK. Connect the BROWN core to

the plug terminal marked “L” or coloured RED.

Electrical connection

You can change the

door from right-hinged

to left-hinged or vice

versa yourself

Illustration shows how easy it is to change the

door from right-hinged to left-hinged - or vice versa.

Take off the table top by removing two screws at the

front of the cabinet and three at the back.

Lay the appliance on its back with the door up.

Remove the door handle.

Unscrew the adjusting screws and take the

brackets off.

Remove the door.

Take off the upper hinge bracket and ret it on the

opposite side of the cabinet.

Replace the door.

Move the pin on the hinge bracket to the other

threaded hole before retting the hinge brackets

on the opposite lower side of the cabinet.

Remember to replace the shim washer on the

hinge pin.

Ret the adjusting screws and the door handle.

Replace the table top.

Specically for Fresh line models 5A

Switch the cabinet off by turning the thermostat

knob to ”0”. Empty the cabinet and begin by

removing the door handle. Tilt the cabinet 40°

in order to gain access to the lowest hinge.

Remove the adjustable feet. Remove the three

screws holding the lowest bracket in place using

a Phillips screwdriver. (1). Remove the door

and unscrew the three screws from the bracket

on the base on the cabinet (2).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram FS 120-II Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info