Bedienungsanleitung Gram kf 20202g (Seite 25 von 40) (Englisch, Holländisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

358150

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Illustration shows how easy it is to change the

doors from right-hinged to left-hinged - or vice versa.

(The table top on model KF 130 and KF 132 should

be taken off first by removing two screws at the front

of the cabinet and three at the back).

The fridge/freezer must not be laid horizontally

while being transported or moved. If the appliance

has been tilted more than 40°, the power supply

must not be connected until the appliance has

stood upright for at least two hours.

The appliance is intended for connection to alternating

current. The connection values for voltage (V) and

frequency (Hz) are given on the nameplate in the

cabinet.

Power must be connected via a wall socket with switch.

The wall socket should be easily accessible.

All earthing requirements stipulated by the local

electricity authority must be observed. The appli-

ance plug and wall socket should then give cor-

rect earthing. If in doubt, contact your local suppli-

er or an authorised electrician.

WARNING

The flexible cord (mains lead) fitted to this appli-

ance has three cores for use with a 3-pin 13-amp

or 3-pin 15-amp plug. If a BS 1363 (13-amp) fused

plug is used, it should be fitted with a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in

accordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug.

Proceed as follows:

Connect the GREEN-AND-YELLOW core to the

plug terminal marked “E” or by an earth symbol, or

coloured GREEN or GREEN-AND-YELLOW. Con-

nect the BLUE core to the plug terminal marked “N” or

coloured BLACK. Connect the BROWN core to the

plug terminal marked “L” or coloured RED.

Electrical connection

You can change the

door from right-hinged

to left-hinged or vice

versa yourself

Reversing the freezer door:

Unscrew the door and the bracket. Turn the door

180°. Re-attach the door and bracket on the opposite-

side.

Switch the cabinet off by turning the thermostat

knob to ”0”. Empty the cabinet and lay the

appliance on its back with the doors up. Begin by

removing the door handles. Tilt the cabinet 40° in

order to gain access to the lowest hinge. Remove

the adjustable feet.

Remove the three screws holding the lowest

bracket in place using a Phillips screwdriver. (1).

Remove the door and unscrew the three screws

from the bracket on the base on the cabinet (2).

Before refitting the brackets on the opposite side of

the cabinet, move the threaded pin on the hinge

bracket to the other threaded hole. Remove the

threaded pin under the control panel using a Phillips

screwdriver and move it to the opposite side. (3).

Refit the door and screw the bottom hinge into

position using a Phillips screwdriver. Refit the

adjustable feet and, finally, refit the door handle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram kf 20202g Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info