Bedienungsanleitung Gram kf 245 g (Seite 26 von 40) (Englisch, Holländisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

354308

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

The temperature in the freezer is closely related to

the setting in the refrigerator in cabinets with only

one compressor.

If quick freezing down is required the cabinet

should be set to run at the lowest temperature, i.e.

„Max”. As this setting affects both the refrigerator

and the freezer, personal experience should be

used to determine how long the quick-freeze (and

thus the low refrigerator temperature) should last.

After freezing down, the normal temperature setting

should again be chosen.

PLEASE NOTE!

Pack your frozen foods in airtight and watertight

material in order to avoid drying out. Portions should

be as flat as possible to allow rapid freezing down.

If during transport the fridge/freezer has been laid

down, or if it has been stored in cold surroundings

(colder than +5°C) it must be allowed to stabilise for

at least two hours before being switched on.

Start the fridge/freezer by plugging into a wall socket.

Important! If the mains lead has been damaged, it

must be replaced with a corresponding type supplied

by Gram A/S or one of Gram’s service centres.

When the appliance is started the thermostat should

be in its middle setting. After an hour or two the

cabinet temperature will have fallen.

If a lower temperature is required, turn the thermostat

knob towards „Max”. If a higher temperature is

required, turn the knob towards „0”. Refrigeration is

switched off when the thermostat knob setting is „0”.

Freezing down

Changing the temperature

Starting up

Specifically for Fresh line models 4A

Switch the cabinet off by turning the thermostat

knob to ”0”. Empty the cabinet and begin by

removing the door handles. Tilt the cabinet 40° in

order to gain access to the lowest hinge. Remove

the adjustable feet. Remove the three screws

holding the lowest bracket in place using a Phillips

screwdriver. (1). Remove the refrigerator door and

unscrew the three screws from the bracket on the

base on the cabinet (2).

Before refitting these brackets on the opposite side

of the cabinet, move the threaded pin on the hinge

bracket to the other threaded hole. Remove the two

screws holding the middle hinge using a Phillips

screwdriver (3). Remove the freezer door. Use the

screws from the opposite side to cover the holes.

Remove the threaded pin under the control panel

using a Phillips screwdriver and move it to the

opposite side. (4). Refit the freezer door by pushing

it onto the upper threaded pin. Refit the middle hinge

on the opposite side and screw it into position using

a Phillips screwdriver. Refit the refrigerator door

and screw the lowest hinge into position using a

Phillips screwdriver. Refit the adjustable feet and,

finally, refit the door handles.

Brief temperature variations are normal and occur when:

- the cabinet is filled with fresh items,

- a door is left open for longer periods,

- the refrigerating/freezing element defrosts.

Items of food in the cabinet will not be affected

by these variations and the temperature will quickly

return to normal.

Brief temperature varia-

tion

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram kf 245 g Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info