Bedienungsanleitung Gram KS220 (Seite 23 von 36) (Englisch, Holländisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

482109

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Illustration shows how easy it is to change the

door from right-hinged to left-hinged - or vice versa.

Lay the appliance on its back with the door up.

Remove the door handle.

Take off the upper hinge bracket and remove the door.

Unscrew the adjusting screws from the lower hinge

brackets and take the brackets off.

Move the pin on the hinge bracket to the other

threaded hole before refitting the hinge brackets

on the opposite lower side of the cabinet.

Remember to replace the shim washer on the

hinge pin.

Refit the adjusting screws.

Replace the door.

Refit the upper hinge bracket on the opposite side.

Refit the door handle.

The appliance is intended for connection to alternating

current. The connection values for voltage (V) and

frequency (Hz) are given on the nameplate in

the cabinet.

Power must be connected via a wall socket with switch.

The wall socket should be easily accessible.

All earthing requirements stipulated by the local

electricity authority must be observed. The appli-

ance plug and wall socket should then give cor-

rect earthing. If in doubt, contact your local suppli-

er or an authorised electrician.

WARNING

The flexible cord (mains lead) fitted to this appliance

has three cores for use with a 3-pin 13-amp or 3-pin

15-amp plug. If a BS 1363 (13-amp) fused plug is

used, it should be fitted with a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in accord-

ance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug.

Proceed as follows:

Connect the GREEN-AND-YELLOW core to the

plug terminal marked “E” or by an earth symbol,

or coloured GREEN or GREEN-AND-YELLOW.

Connect the BLUE core to the plug terminal

marked “N” or coloured BLACK. Connect the

BROWN core to the plug terminal marked “L” or

coloured RED.

Electrical connection

You can change the

door from right-hinged

to left-hinged or vice

versa yourself

Specifically for Fresh line models 4A

Switch the cabinet off by turning the thermostat

knob to ”0”. Empty the cabinet and begin by

removing the door handle. Tilt the cabinet 40° in

order to gain access to the lowest hinge. Remove

the adjustable feet. Remove the three screws

holding the lowest bracket in place using a Phillips

screwdriver. (1). Remove the door and unscrew

the three screws from the bracket on the base on

the cabinet (2).

Before refitting the brackets on the opposite side of

the cabinet, move the threaded pin on the hinge

bracket to the other threaded hole. Remove the

threaded pin under the control panel using a Phillips

screwdriver and move it to the opposite side. (3).

Refit the door and screw the bottom hinge into

position using a Phillips screwdriver. Refit the

adjustable feet and, finally, refit the door handle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram KS220 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info