36
GB
Please note that these instructions apply
to all KS models and therefore the acces-
sories/equipment described can vary from
model to model.
WARNING
Old refrigerators and freezers are often
fitted with complicated latches that can
only be opened from the outside. If you
have an old unit like this stored away
somewhere, or if you scrap it, remember
to destroy the latch to prevent children
from being exposed to danger by
getting locked inside the unit.
Note! Please also observe the environ-
mental rules on disposal. See section
“Disposal”.
Please read the section on setting up and
building in, starting up, temperature control
and electrical connection before using your
refrigerator.
On receipt, check to ensure that the refri-
gerator has not become damaged in trans-
port. Transport damage should be repor-
ted to the local supplier before the refrige-
rator is put to use.
Fold out the final pages with illustrations.
You will then be able to follow text and
pictures at the same time.
For safety and operational reasons, do not
set up the refrigerator outdoors.
Your refrigerator should be placed in a dry
room.
The refrigerator is designed for tempera-
ture class N in accordance with European
standard EN 153.
The surface on which the appliance is
placed must be plane. Do not use a plinth
or similar.
Never place the refrigerator close to sour-
ces of heat such as ovens or radiators,
and avoid placing it in direct sunlight.
It is important that the refrigerator stands
completely level and that there is good air
circulation over, under and around it.
The dimensions give the actual size of the
opening. The figures in brackets apply to
combination units.
Single cabinets require a circulation area
of at least 200 cm
2
, combination units 300
cm
2
.
1A Building in with ventilation grill
Refrigerator or refrigerator/freezer
combination in a standard kitchen ele-
ment with sufficient ventilation for the
compressor around the refrigera-
tor/combination.
1B Building into a refrigerator element
Refrigerator or refrigerator/freezer
combination with integral ventilation.
Air flows in through the plinth and is led
to the rear of the cabinet.
The appliance is intended for connection
to alternating current. The connection valu-
es for voltage (V) and frequency (Hz) are
given on the nameplate in the cabinet.
Power must be connected via a wall
socket with switch. The wall socket should
be easily accessible.
