Bedienungsanleitung Gram ksi 140 00 (Seite 22 von 36) (Englisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

354524

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

Height

Width

Depth

TYPE

KSI 140

862

558

540

See also figures .

Min. dimension (mm)

The appliance is intended for connection to alternating

current. The connection values for voltage (V) and

frequency (Hz) are given on the nameplate in

the cabinet.

Power must be connected via a wall socket with switch.

The wall socket should be easily accessible.

All earthing requirements stipulated by the local

electricity authority must be observed. The

appliance plug and wall socket should then give

correct earthing. If in doubt, contact your local

supplier or an authorised electrician.

WARNING

The flexible cord (mains lead) fitted to this appliance has

three cores for use with a 3-pin 13-amp or 3-pin 15-amp

plug. If a BS 1363 (13-amp) fused plug is used, it

should be fitted with a 13-amp fuse.

IMPORTANT

The cores in this mains lead are coloured in

accordance with the following code:

GREEN-AND-YELLOW: EARTH

BLUE: NEUTRAL

BROWN: LIVE

These colours might not correspond with the colour

markings identifying the terminals in your plug.

Proceed as follows:

Connect the GREEN-AND-YELLOW core to the

plug terminal marked “E” or by an earth symbol,

The appliance must not be laid horizontally while

being transported or moved. If the appliance has

been tilted more than 40°, the power supply must

not be connected until the appliance has stood

upright for at least two hours.

Electrical connection

Remove the kitchen element door and attach the

bracket 1 by screwing four screws 10 into

the pre-drilled holes . Attach the kitchen

element door to the appliance door. See .

The position of the door can be adjusted by turning

screw 7 using a cross-slot screwdriver.

After adjustment, fasten the door in position using

the bolt 8 .

or coloured GREEN or GREEN-AND-YELLOW.

Connect the BLUE core to the plug terminal marked

“N” or coloured BLACK. Connect the BROWN core

to the plug terminal marked “L” or coloured RED.

lying flat.

Make two marks using the accompanying template

4 .

Attach the bracket 1 to the door at the marks

using two screws 10 . See figure .

Centrally position the appliance door on the kitchen

element door.

8 8a

Installation

For a list of screws and fittings, see page 35.

Insert the appliance into the recess and push its

door hinge side against the recess wall, .

Fasten the appliance securely to the recess wall

using two screws 11 in each hinge. Also

fasten the appliance to the base of the recess using

two screws 10 , .

Position the upper covering strip 5 between the

appliance and the top of the recess and fasten it securely

to the recess top using three screws 10 , ,

Cover the ventilation opening between the

appliance and the bottom of the recess with the

base strip, 6 , and fasten it in place using two

screws 10 . Finally, cover the screw heads

with caps 14 . Screw the adjusting screws

7 into the two pre-drilled holes on the upper edge

of the door . As shown in figure , or

, it is easiest to assemble the door while it is

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram ksi 140 00 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info