Bedienungsanleitung Gram ksi 200 00 g (Seite 26 von 40) (Englisch, Dänisch, Schwedisch, Norwegisch, Finnisch)

354527

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

10a

Remove the kitchen element door and attach the

bracket 1 by screwing four screws 10 into

the pre-drilled holes . Attach the kitchen

element door to the appliance door. See .

The position of the door can be adjusted by turning

screw 7 using a cross-slot screwdriver.

After adjustment, fasten the door in position using

the bolt 8 .

Attach the bracket 3 to the bottom corner of the

appliance door using screw 12 and then to the

kitchen element door using screw 10 .

Attach the decorative strip 2 to the adjustable

bracket 1 .

You can change the doors from

right-hinged to left-hinged or vice

versa yourself

Remove the hinges from the appliance and refit

them as follows: upper right hinge to lower left of

door; lower right hinge to upper right of door.

Starting up

If during transport the appliance has been laid

down, or if it has been stored in cold surroundings

(colder than +5°C) it must be allowed to stabilise

for at least two hours before being switched on.

Start the appliance by plugging it into a wall socket.

Please note! If the mains lead has been

damaged, it must be replaced with a

corresponding type supplied by Gram A/S or

one of Gram’s service centres.

Changing the temperature

When the appliance is started the thermostat should

be in its middle setting. After an hour or two the

cabinet will have cooled down. If a lower

temperature is required, turn the thermostat knob

towards „Max.”. If a higher temperature is

required, turn the knob towards „0”.

Refrigeration is switched off when the thermostat

knob setting is „0”.

Changing the temperature

Make two marks using the accompanying template

4 .

Attach the bracket 1 to the door at the marks

using two screws 10 . See figure .

Centrally position the appliance door on the kitchen

element door.

The control panel is positioned behind the door at the

top of the cabinet. The switch furthest to the right

starts the freezer. The green lamp lights up, showing

that power is on. The thermostat knob can be set

from 1 (warmest) to 7 (coldest).

When the appliance is started the thermostat should be

in its middle setting „4”. After an hour or two the cabinet

will have cooled down. If a lower temperature is required,

turn the thermostat knob towards „7”. If a higher

temperature is required, turn the knob towards „1”.

The compressor is switched off when the thermostat

knob setting is „0”.

The red lamp lights up when the temperature in the

cabinet is not in accordance with the thermostat setting.

Freezing down

The most effective freezing down is achieved by pressing

the „quick-freeze” switch ¹ 24 hours before items are to

be placed in the cabinet. The yellow lamp º remains lit

for as long as „quick-freeze” is switched on.

When freezing down is completed - after a day or two

depending on the quantity of items placed in the cabinet

- switch off „quick-freeze”, and the yellow lamp

will go out.

Please note! The compressor runs conti-

nuously during freezing down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gram ksi 200 00 g Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info