637239
6
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
6
GR-18_Copter_jh_V1
Ð Protect the receiver from dust, dirt, moisture and other for-
eign parts. Do not expose this equipment to vibration and
excessive heat or cold. The remote control operation may
be carried out only in “normal” ambient temperatures, in a
range from -10 ° C to +55 ° C.
Ð Use all of your Hott components only with the latest Soft-
ware version
Ð If any questions arise that can not be ascertained with the
help of the operating manual, please contact us (contact
information, see page 3) or another expert.
WARNING
Pay attention, even while programming, that the connected
motors do not start suddenly. Injury risk by the turning pro-
pellers!
Avoid shock and pressure. Check the receiver regularly for
damages to the housings and cables after every flight. Dam-
aged or wet electronic components, even if re-dried, should
no longer be used.
Installation in the model (Copter)
The receiver must be placed in line with one side of the Cop-
ter, secure it to the receiver holder. The lower surface of the
receiver must always be parallel to one of the copter sides.
Put some double-sided tape on the bottom of the receiver
and use the optimal double taped pads S8376 for Gr-18,
S8377 for Gr-24 PRO.
Binding
The binding is only possible if the receiver has not yet been
binded to another transmitter (red LED blinks). Pushing the
SET button the receiver will be set in Bind mode.
If you want to bind an already binded receiver to another
memory, follow the next steps:
Ð Turn off the RF module in the “Basic setting“ menu (see
transmitter’s manual)
Ð Switch on the receiver pushing the SET button to bring it in
bind mode
Ð Start the binding in the “Basic setting“ menu
Ð If within 10 seconds the red light turns off and the green
LED will light, the binding process was successful.
Ð Your RC system is now ready for use.
Ð If the red LED is still on it means that the binding process
didn’t work properly. In this case repeat the procedure.
!
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Graupner 33579 - GR-18 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Graupner 33579 - GR-18

Graupner 33579 - GR-18 Bedienungsanleitung - Deutsch - 27 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info