Bedienungsanleitung Graupner GR-32L DUAL HoTT - S1023 (Seite 5 von 15) (Englisch)

747930

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

- Mount the bound receiver in the target place in the model.

- Switch on the RC system so that you could observe the movement of the servos.

- Put the model on a at surface (pavement, closely mown grass or earth), and ensure

that the receiver antenna should be at least 15cm above from the ground.

- Face the model with the transmitter in your normal ying position, the antenna on

the transmitter shouldn’t be toward the model directly and it keeps stand horizontally

during range checking

- Enter range check mode of your specic transmitter and follow the procedures of your

specic transmitter to check the range. the transmitter repeat a single beep with a

regular rhythm, indicating the Range checking is processed normally.

- Walk over 50 meters away from the model with controlling the transmitter sticks

constantly and check whether the model is operating normally. You should have total

control of the model with the trainer switch pulled

- If control issues exist within 50 meters, the system should not be used. And contact

your local Service Department of SJ INCORPERATED.

- Range-check is automatically terminated in 90 seconds and it is also terminated by

turning off the range check function of your specic transmitter. the status LED on the

receiver turns solid green when terminated.

- Have your helper position the model and check effective radio range before every

ight while simulate all the servo movements which will take place when the model is

in ght. The ground range must always be at least 50m in order to ensure safe and

reliable model control.

The last bound receiver is the master receiver when the system would be in use. Every

telemetry sensors installed in the model must be connected to the master receiver,

since the only master receiver transmits sensor data through the downlink channel. The

second and all further receivers are operated as the slave mode which are connected

in parallel to the master, with the downlink channel switched off. The control signals can

be passed to a number of receivers simultaneously and also the different signal can be

assigned to each receiver through the Channel Mapping function of the transmitter or

the optional SMART BOX. The typical example would be the use of two servos for each

aileron, etc.

NOTICE : Make sure to double check that transmitter is bound to receiver by turning

off/on transmitter’s power after binging process is completed

2) Range checking

Before every ying session and especially with a new model, it is important to perform a

range check. All Graupner aircraft transmitters incorporate a range testing system which,

when activated, reduces the output power, allowing a range check. Notice that every

ying must not be permitted in the range checking mode and the model is restrained on

the ground. After binding the receiver to the transmitter, switch the on transmitter and

the receiver and wait until the status LED on the receiver turns solid red.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Graupner GR-32L DUAL HoTT - S1023 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info