467111
19
Zoom out
Zoom in
Vorherige Seite
1/345
Nächste Seite
19
General operating notices
Charging with automatic chargers
To achieve quicker recharging of the single cell LiIo
battery, Graupner automatic chargers can also be
used. The table below shows a selection of these
chargers.
Recommended chargers (accessory)
Order
No. Designation
Input voltage 220 V
Input voltage 12 V
suitable for
battery types
integr. balancer
NiCd
NiMH
LiPo/LiIo
lead battery
6411 Ultramat 8 x x x x x
6463 Ultramat 12 plus x x x x x x
6464 Ultramat 14 plus x x x x x x x
6466 Ultra Trio plus 14 x x x x x x x
6468 Ultramat 16S x x x x x x x
6469 Ultra Trio Plus 16 x x x x x x
6470 Ultramat 18 x x x x x x x
6475 Ultra Duo Plus 45 x x x x x x x
6478 Ultra Duo Plus 60 x x x x x x x
6480 Ultra Duo Plus 80 x x x x x x x
Charger cable, No. 3022 is additionally needed for the transmitter
and charger cable, No. 3021 is additionally
needed for the receiver.
Other charger units and details about the listed chargers can
be found in the Graupner RC main catalog or in Internet at
www.graupner.de.
The charger socket is equipped standard with a
diode to protect against reversed polarity. Original
Graupner automatic chargers also detect battery
voltage polarity.
Observe the confi guration notices for the charger
used.
First connect the charger cable's banana
plugs to the charger and only then con-
nect the cable's other end into the charg-
ing jack on the transmitter. Never allow the bare
ends of the banana plugs to come into contact
with one another when the other end of the cable
is plugged into the transmitter.
Charging current may not exceed 1.5 A as other-
wise the diode, and perhaps other components,
could be damaged. If necessary, limit the current
at the charger.
mc-32 HoTT charging jack polarity
The charger cables on the market from other manu-
facturers often have different polarities. Therefore use
only an original Graupner charger cable, No. 3022.
Removing the transmitter's battery
To remove the transmitter's battery, fi rst unlatch the
cover of the battery compartment on the rear side of
the transmitter housing then remove the cover.
Take out the transmitter's battery then disconnect the
transmitter battery's connector by carefully pulling on
the supply line cable.
Inserting the transmitter's battery
The battery connector is protected against a reverse
polarity connection by two slanted edges, see illustra-
tion. When correctly plugged in, the
unconnected pin of the connector
is at the bottom, as shown in the
illustration. The plus pole (red lead)
is in the middle and the minus pole
(brown or black lead) is toward the
antenna side.
Never try to force the connector
onto its circuit-board socket.
Place the battery into its compartment and close the
transmitter's cover.
Battery operation timer at the bottom left of the screen
This timer shows the transmitter's cumulative operating
time since the transmitter's battery was last charged.
This timer is automatically reset to "0:00" when the
transmitter is switched on and its battery voltage is
signifi cantly higher than when the transmitter was last
used, e. g. because the battery was charged.
#01 0:00h
Stop watch
Flight tim
K78
0:00.0
4.1V
0:00.0
00
0
0
0:00h
M
V
Transmitter
connector polarity
Battery connector
19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

graupner-mc-32-hott

Suche zurücksetzen

  • meine "modellauswahl" ist weg, wie bekomme ich sie wieder? Eingereicht am 25-1-2020 10:42

    Antworten Frage melden
  • beim Einschalten des Senders leuchtet die blaue „WARNING“-LED rechts neben
    dem Ein-/Ausschalter blinkt und es ertönen akustische Warnsignale ohne Ende, wie wird
    der Alarm abgestellt ?
    Sender blockiert und lässt sich nicht mehr programmieren ! Eingereicht am 2-9-2018 01:24

    Antworten Frage melden
  • Wo muss der schalter stehen bei der mc 32 wenn ich aus schallte Eingereicht am 25-6-2018 12:21

    Antworten Frage melden
  • Wie kann ich bei der mc- 32 das obere Display auf den Vario- Sensor umstellen? Eingereicht am 6-4-2017 14:22

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Graupner MC 32 HOTT wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Graupner MC 32 HOTT

Graupner MC 32 HOTT Bedienungsanleitung - Deutsch - 320 seiten

Graupner MC 32 HOTT Bedienungsanleitung - Holländisch - 328 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info