Bedienungsanleitung Gree K5NNA2C (Seite 36 von 40) (Englisch)

725705

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Refrigeration equipment Checking

Repairs to sealed components

During repairs to sealed components, all electrical supplies shall be disconnected from

the equipment being worked upon prior to any removal of sealed covers, etc. If it is

absolutely necessary to have an electrical supply to equipment during servicing, then a

permanently operating form of leak detection shall be located at the most critical point

to warn of a potentially hazardous situation.

Particular attention shall be paid to the following to ensure that by working on electrical

components, the casing is not altered in such a way that the level of protection is affected.

This shall include damage to cables, excessive number of connections, terminals not made

to original specification, damage to seals, incorrect fitting of glands, etc.

Electrical devices checking

Where electrical components are being changed, they shall be fit for the purpose and

to the correct specification. At all times the manufacturer’s maintenance and service

guidelines shall be followed. If in doubt, consult the manufacturer’s technical department

for assistance.

The following checks shall be applied to installations using flammable refrigerants:

Initial safety checks shall include:

Repair and maintenance to electrical components shall include initial safety checks

and component inspection procedures. If a fault exists that could compromise safety, then

no electrical supply shall be connected to the circuit until it is satisfactorily dealt with. If the

fault cannot be corrected immediately but it is necessary to continue operation, an

adequate temporary solution shall be used. This shall be reported to the owner of the

equipment so all parties are advised.

Specialist’s Manual

The ventilation machinery and outlets are operating adequately and are not obstructed;

If an indirect refrigerating circuit is being used, the secondary circuit shall be checked

for the presence of refrigerant;

The actual refrigerant charge is in accordance with the room size within which the

refrigerant containing parts are installed;

That there is continuity of earth bonding.

Marking to the equipment continues to be visible and legible. Markings and signs that

are illegible shall be corrected;

That capacitors are discharged: this shall be done in a safe manner to avoid possibility

of sparking;

That no live electrical components and wiring are exposed while charging, recovering

or purging the system;

Refrigeration pipe or components are installed in a position where they are unlikely to

be exposed to any substance which may corrode refrigerant containing components,

unless the components are constructed of materials which are inherently resistant to

being corroded or are suitably protected against being so corroded.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gree K5NNA2C Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info