Bedienungsanleitung Grohe 39368 (Seite 11 von 66) (Alle Sprachen)

759832

Zoom out

Zoom in

Vorherige Seite

1/66

Nächste Seite

Activating cleaning mode,

see page 2.

Triggering flushing and signalling status,

see page 2.

*F: Solenoid valve intact / defective

*G: Temperature sensor intact / defective

Making settings, see page 3

Activating setting mode, see Fig [1].

Setting the flow volume, see Fig. [2a] .

Setting the programme, see Fig. [2b].

Observe programme table, see fold-out page I.

Setting mode is automatically terminated after 3 minutes.

Maintenance, see page 4

Demounting ceramic and shut off water supply,

see Fig. [1] and [2].

Inspect and clean all components and replace if necessary.

I. Power supply unit, see Fig. [3]

II. Solenoid valve and filter, see Fig. [4].

III. Siphon with temperature sensor, see Fig. [5].

IV. Electronic, see Fig. [6].

Assamble in reverse order.

Replacement parts

see fold-out page I

Disposal note

Fault / Cause / Remedy

This category of device does not belong in the

domestic waste, but must be disposed of separately

in accordance with the relevant national regulations.

Fault Cause Remedy

Water not flowing • Water supply interrupted

• Filter in solenoid valve blocked

• Solenoid valve defective

• Plug-in connector without contact

• No voltage

- Power supply unit defective

- Power supply switched off

• Outlet clogged

• Temperature sensor defective

• Through high ambient temperature, the

water temperature in the siphon and in the

water supply is > 35 °C

• Flushing during continuous use is activated

(Flushing is initiated every 8 min.

independent of the use)

- Open shut-off valves

- Clean filter

- Replace solenoid valve

- Check plug-in connector

- Replace power supply unit

- Switch on voltage supply

- Clean outlet

- Replace siphon with temperature sensor

- Ensure operating temperature of the water in the

water supply

- After drop of the temperature in the siphon the

elektronic terminates the mode flushing during

continuous use automatically

Undesired water

flow

• Automatic flushing activated

• Through high ambient temperature, the

water temperature in the siphon is > 35 ° C

• Solenoid valve defective

- The elektronic triggers a flushing to reduce the

water temperature in the siphon

- Replace solenoid valve

Flow volume too

low

• Solenoid valve defective

• Filter in solenoid valve blocked

- Replace solenoid valve

- Clean filter

Bluetooth®

Connection not

possible

• No reception/connection interrupted

• Interferences in the reception area

• Obstacle in transmission path

- Turn back the device to receiving range

- Turn off the source of interference

(observe manufacturer´s documentation)

- Remove from radio path

Interrupted while

operating

• Interferences in the reception area

• Obstacle in transmission path

- Turn off the source of interference

(observe manufacturer´s documentation)

- Remove from radio path

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grohe 39368 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info