505519
13
Zoom out
Zoom in
Vorherige Seite
1/34
Nächste Seite
Adjusting the audio level
For the best performance, you must set LEVEL (MIN/MAX) on the side of the amplifier to adjust
the level of the audio signals.
1. Use a screwdriver to turn LEVEL(MIN/MAX) fully to MIN
2. Turn the auto sound system’s volume control to about two-third of its full range.
3. Adjust LEVEL(MIN/MAX) to a comfortable listening level
4. Turn up the auto sound system’s volume control until the sound begins to distort.
Then immediately turn the volume down to a point just before where the distortion
began.
Caution: Never turn up the auto sound system’s volume control more than needed to
adjust the audio level, more than two thirds of its maximum volume.
5. Adjust LEVEL (MIN/MAX) until the sound is at the maximum level you want the
amplifier two produce.
6. Adjust the auto sound system’s volume control to a comfortable listening level.
Trouble shooting
This power amplifier has protection features to prevent any damages from misuse or faulty conditions. If the unit
senses excessive heat, short circuited speakers or overload, the protection indicators will light, and the system will
be turned off. In order to check the occurred problem, you should turn all levels down and all power off and
carefully check the installation for wiring mistakes or short. If the amplifier shuts down due to excessive heat, the
protection indicators will not light: simply allow time for the unit to cool.
Before removing your amplifier, refer to the list below and follow the suggested procedures.
Always test the speakers and their wires first.
Problem Check points
Amplifier is
not powered up
Check that there is battery power on the +12V terminal.
Check that remote terminal has at least +12V DC remote
connection.
Check a good ground connection. Check all fuses.
Check the protection LED is not lit.
Protection LED
illuminates when
amplifier is powered up
Check shorts on speaker wires.
Remove speaker wires and reset the amplifier. If the
protection LED still comes on, then the amplifier is faulty.
Fuse blowing
Check that the minimum speaker impedance is correct.
Check short on power cable and vehicle chassis.
Overheating
Check that the minimum speaker impedance is correct.
Check speaker shorts.
Check that there is a good airflow around the amplifier.
Sound too low /
Distorted sound
Check that the input level control is set to match the output
level of the unit.
Check the head unit volume.
Check speaker shorts.
Check that crossover frequencies have been properly set.
High hiss /
engine noise
in speakers
Check a good ground and for speaker shorts.
Disconnect all RCA inputs from the amplifier. If hiss/noise
disappears, check it with a good RCA interconnect. Then
check the component driving the amplifier.
Specifications
Model
GZIA
2075HPX
GZIA
2125HPX
GZIA
2230HPX
GZIA
4110HPX
RMS power @ 2 ,
1% THD
CEA Standard CEA-2006-A
2 x 75 W 2 x 125 W 2 x 230 W 4 x 110 W
RMS power @ 4 ,
1% THD
CEA Standard CEA-2006-A
2 x 60 W 2 x 80 W 2 x 150 W 4 x 70 W
RMS power @ 4 Brid
g
ed
14,4 V, 10% THD
1 x 200 W 1 x 300 W 1 x 540 W 2 x 250 W
Damping factor
> 70 > 70 > 70 > 70
Signal to noise ratio
80 dB 80 dB 80 dB 80 dB
X-over crossover
40 – 3000 Hz /
30 – 250 Hz
40 – 3000 Hz /
30 – 250 Hz
40 – 3000 Hz /
30 – 250 Hz
40 – 3000 Hz /
30 – 250 Hz
Bass boost
- - -
0 / +6 / +12
dB
Bass boost Frequency
- - - 60 Hz
Frequency response
10 Hz - 30 kHz 10 Hz - 30 kHz 10 Hz - 30 kHz 10 Hz - 30 kHz
Input sensitivity
0,2 – 6 V 0,2 – 6 V 0,2 – 6 V 0,2 – 6 V
Channel separation
60 dB 60 dB 60 dB 60 dB
THD
< 0.08 < 0.08 < 0.1 < 0.8
Dimensions
W x H x L mm
170 x 255 x 50 200 x 255 x 50 260 x 255 x 50 280 x 255 x 50
Dimensions
W x H x L inch
6.60“ x
10.04“ x 1.97“
7.87“ x
10.04“ x 1.97“
10.24“ x
10.04“ x 1.97“
11.02“ x
10.04“ x 1.97“
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ground zero GZIA 2230HPX wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info