Bedienungsanleitung Ground zero GZRA 2.200G-W (Seite 46 von 50) (Deutsch, Englisch)

505558

Zoom out

Zoom in

Vorherige Seite

1/50

Nächste Seite

Controls and functions

Power terminals

GND -> Ground connection

REM -> Remote antenna terminal

BATT -> +12 Volt

2 Speaker terminals For connection of the speakers

3 Satus indication

GREEN – OK

RED – Error

4 Remote control input For connection of the bass remote control.

High pass controller

(Subsonic)

Set the filter switch to „HIGH“ position.

Adjust the variable HPF crossover frequency to the desired frequency

using the controller. All frequency between 5 and 4000Hz will be

reproduced.

6 Low pass controller

For subwoofer and Kickwoofer operation -

Only frequencies from 40Hz to 4000Hz will be reproduced (GZRA

4.100G(-W)) / 40 – 500 Hz (GZRA 2.200G(-W)) or 30 – 250 Hz (GZRA

1.600D(-W)) (depending on the LPF filter controller position). Set the

filter switch to „LOW“ position. Adjust the variable LPF frequency to the

desired frequency using the controller.

At LPF adjustment, also the Highpass (Subsonic) is activated.

This equals a Bandpass filter of 5 – 4000Hz (GZRA 4.100G(-W)) /

5 – 500 Hz (GZRA 2.200G(-W)).

7 Bass boost controller For adjusting of the bass boost level in the range from 0 to +12 dB.

8 Input level controller With this controller you can adjust the input sensitivity.

Subsonic controller (GZRA

1.600D)

For adjustment of the subsonic filter in a range of 5 – 50 Hz.

Phase Shift Regler

(GZRA 1.600D)

This controller allows you to fit the subwoofer channel in-phase to the

front system.

11 Mode Schalter

Adjust the crossover for the chosen utilization.

LPF – Only bass frequencies below 40Hz -4000 Hz (GZRA 4.100G(-W)) /

40 – 500 Hz (GZRA 2.200G(-W)) will be reproduced.

FULL – All frequencies will be reproduced.

HPF – Only middle and high frequencies (over 5Hz – 4000Hz) will be

reproduced.

At LPF adjustment, also the Highpass (Subsonic) is activated.

This equals a Bandpass filter of 5 – 4000Hz (GZRA 4.100G(-W)) /

5 - 500 Hz (GZRA 2.200G(-W)).

12 Cinch inputs

Terminal for connection of the RCA wires.

To avoid failure, please use high quality RCA wires.

13 Output For connection of additional amplifiers.

Turning on the amplifier

The amplifier automatically turns on a few seconds after you turn on your radio.

Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools

(At about 80° / 176° F).

Adjusting the audio level

1. LEVEL (Min/Max): Turn fully counter- clockwise to MIN position

2. Turn the auto sound system's volume control to about two-third of its full range.

3. Adjust LEVEL to a comfortable listening level.

Connecting the speaker for trimode operation - notes

TRI MODE operation output allows a subwoofer to be operated in mono mode while the main speakers are

playing in stereo. Leave the crossover switch on “Full” position.

Use 100 volt, non-polar capacitors for a high pass crossover to filter out low frequencies and Air- core or

Ferrit- ore coils with a minimum diameter of 1 mm / 0.039” for the lowpass crossover to filter out high

frequencies.

The capacitor and inductor values as written in the below table. The front and rear channels of this amplifier get

this capability. Only the rear left and right channels are shown on the following pictures.

Values for 6dB passive crossover

Frequency

Inductor

Capacitor

80 Hz

7,5 mH

470 uF

100 Hz

6,5 mH

330 uF

120 Hz

5,5 mH

370 uF

150 Hz

4 mH

220 u

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ground zero GZRA 2.200G-W Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info