505530
9
Zoom out
Zoom in
Vorherige Seite
1/11
Nächste Seite
Trouble shooting / En cas… de non fonctionnement
This power amplifier has protection features to prevent any damages from misuse or faulty conditions. If the unit
senses excessive heat, short circuited speakers or overload, the protection indicators will light, and the system
will be turned off. In order to check the occurred problem, you should turn all levels down and all power off and
carefully check the installation for wiring mistakes or short. If the amplifier shuts down due to excessive heat, the
protection indicators will not light: simply allow time for the unit to cool. Before removing your amplifier, refer to
the list below and follow the suggested procedures.
Always test the speakers and their wires first.
Problem Check points
Amplifier is
not powered up
Check that there is battery power on the +12V terminal.
Check that remote terminal has at least +12V DC remote connection.
Check a good ground connection. Check all fuses.
Check the protection LED is not lit.
Protection LED illuminates
when amplifier is powered
up
Check shorts on speaker wires.
Remove speaker wires and reset the amplifier. If the protection LED still comes on,
then the amplifier is faulty.
Fuse blowing
Check that the minimum speaker impedance is correct.
Check short on power cable and vehicle chassis.
Overheating
Check that the minimum speaker impedance is correct.
Check speaker shorts.
Check that there is a good airflow around the amplifier.
Sound too low / Distorted
sound
Check that the input level control is set to match the output level of the unit.
Check the head unit volume.
Check speaker shorts.
Check that crossover frequencies have been properly set.
High hiss /
engine noise
in speakers
Check a good ground and for speaker shorts.
Disconnect all RCA inputs from the amplifier. If hiss/noise disappears, check it with
a good RCA interconnect. Then check the component driving the amplifier.
Cette amplificateur et équiper de protection pour éviter tous dégâts en cas de mauvaise manipulation .Si l’ampli
détecte une anomalie (court-circuits – surchauffe ) l’ampli se coupe automatiquement . Pour examiner le
problèmes vérifier tous vos branchements , le temps que l’ampli refroidisse . vérifier en premier les Haut parleurs
puis tous les câbles d’alimentation . si le problèmes persiste consulter un technicien.
Problèmes Contrôle Aide
Pas de son
Voyant PWR allumé?
Vérifier le fusible, Contrôler le Câble REMOTE, Contrôler
le+12Volt et la masse
Le Voyant PROTECTION
est allumé ?
Court circuit des Haut-parleurs, ampli surchauffe ou défectueux
Amplificateur ne
se met Pas en
marche
Pas d’alimentation
Vérifier le + 12 volt, la masse, le fusible
Pas d’alimentation sur le
REMOTE
Vérifier le REMOTE sur l’Autoradio
Ampli se met en
PROTECTION a
haut Volume
Vérifier l’Impédance des
Haut-parleurs
Vérifier si l’Impédance sur les connecteurs des haut-parleurs n’est
pas en dessous de 2
Vérifier si l’Impédance sur les connecteurs des haut-parleurs n’est
pas en dessous de 1
Pas de son sur 1
canal
Vérifier câble RCA et ou
câble Haut-parleurs
Câble ou prise (RCA) défectueux
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ground zero Plutonium Reference 2XS wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info