ENGLISH
37
Troubleshooting
If a fault occurs, first refer to this information before you take the device for
repair.
If you are unable to rectify the fault using the information given here, contact
your local dealer or service specialist.
Under no circumstances should you attempt to repair the device yourself, as
this would invalidate the guarantee.
INFORMATION
_______________________________________
PROBLEM
GENERAL
INFORMATION
No sound
The device does not
respond to button
commands
RADIO
Poor radio reception
CD
Playback will not start
The CD player skips
tracks
CD-Rs or CD-RWs
are not being played
back, or being
played back incor-
rectly
POSSIBLE CAUSE
Volume is set too low or
headphones are connected,
mains cable is not correctly
connected
Static electrical discharge
Weak radio antenna signal
Interference from electrical
devices such as televisions,
video recorders, computers,
neon lamps, thermostats
or motors
The CD is damaged or dirty
A stored track memory is being
played
The RANDOM function is acti-
vated
Faulty software or hardware
settings for burning, or the CD
being used is faulty
REMEDY
Increase the volume,
unplug headphones
Connect the mains cable
properly
Switch off device,
disconnect mains cable and
plug it in again after a few
seconds
FM (VHF): redirect the wire
antenna
Switch from stereo to mono
reception
MW: turn whole device
Keep radio recorder away
from electrical devices
Replace or clean the CD
Switch to normal playback
or delete the track memory
Switch off the RANDOM
function
Check the components of
your CD burner/burner
software or change the CD
you are using
