Bedienungsanleitung Grundig GNF41810 (Seite 8 von 44) (Englisch)

574816

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

DISHWASHER / USER'S MANUAL

/44 EN

INSTALLATION

To make the product ready for use, make

sure that the electricity, tap water supply and

water drainage systems are appropriate

before calling the Authorised Service Agent.

If they are not, call a qualified technician

and plumber to have any necessary

arrangements carried out.

Preparation of the location and

electrical, tap water and waste

water installations at the place

of installation is under customer's

responsibility.

Manufacturer shall not be held

responsible for damages arising

from processes carried out by

unauthorised persons.

Prior to installation, visually

check if the product has any

defects on it. If so, do not have

it installed. Damaged products

cause risks for your safety.

Preparation of the location and

electrical, tap water and waste

water installations at the place

of installation is under customer's

responsibility.

Make sure that the water inlet

and discharge hoses are not

folded, pinched or crushed

while pushing the product into

its place after installation or

cleaning procedures.

When placing the product, pay attention not

to damage the floor, walls, piping, etc. Do

not hold the product from its door or panel

to move it.

Appropriate installation

location

• Place the product on a solid and flat

floor that has sufficient load carrying

capacity! The product must be installed

on a flat surface in order for the door to

be closed comfortably and securely.

• Do not install the product at places

where temperature may fall below 0ºC.

• Place the product at least 1 cm away

from the edges of other furniture.

• Place the product on a rigid floor. Do

not place it on a long pile rug or similar

surfaces.

Ensure the power cable does not

get trapped under the product.

• Make sure that you select a location that

will allow you to load and unload the

dishes in a fast and comfortable manner.

• Install the product in a place close to the

tap and the drain. Select the installation

location by considering that it will not

be changed after the connections are

made.

Connecting water supply

• Do not use old or used water inlet hose

on the new product. Use the new water

inlet hose supplied with the product.

• Connect the water inlet hose directly

to the water tap. Pressure coming from

the tap should be minimum 0.3 and

maximum 10 bars. If the water pressure

exceeds 10 bars, a pressure relief valve

should be installed in between.

• Open the taps completely after making

the connections to check for water leaks.

For your safety, close the water

inlet tap completely after the

washing programme is over.

Connection to the drain

Water discharge hose can directly be

connected to the drain hole or sink’s

drainage. The length of this connection must

be min. 50 cm and max. 100 cm from the

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grundig GNF41810 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info