Bedienungsanleitung Grundig GNI 41823 X (Seite 36 von 40) (Englisch)

673425

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

DISHWASHER / USER INSTRUCTIONS

35 / 39

Troubleshooting

• Selected programme is unsuitable. >>> Since rinsing temperature is low at programmes

with short duration, drying performance will also be low. Select programmes with longer

duration for a higher drying performance.

• Surface quality of the kitchen utensils is deteriorated. >>> Desired washing performance

can not be obtained at kitchen utensils with deteriorated surfaces and it is not suitable to

use such utensils in terms of hygiene as well. Also, water can not flow easily on deteriorated

surfaces. It is not recommended to wash such kitchen utensils in dishwasher.

It is normal that drying complaints can be experienced with Teflon kitchen

utensils. It is associated with the structure of Teflon. Since the surface tensions of

Teflon and water are different, water droplets will remain as beads on the Teflon

surface.

Tea, cafe or lipstick stains remain on dishes.

• Selected programme is unsuitable. >>> Select a programme with a higher temperature and

cycle time.

• Surface quality of the kitchen utensils is deteriorated. >>> Tea and cafe stains or other dye

spots may not be cleaned in dishwasher when they have penetrated in deteriorated surfaces.

Desired washing performance can not be obtained at kitchen utensils with deteriorated

surfaces and it is not suitable to use such utensils in terms of hygiene as well. It is not

recommended to wash such kitchen utensils in dishwasher.

• Detergent is stored under unsuitable conditions. >>> If you are using powder detergent, do

not store the detergent package in humid places. Keep it in a closed container if possible. For

ease-of-storing, we recommend you to use tablet detergents.

Lime traces remain on dishes and glassware gains a misty appearance

• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary.

Increase the rinse aid setting if there is enough amount of rinse aid in the machine.

• Water hardness setting is low or salt level is insufficient >>> Measure the hardness of the

supply water appropriately and check the water hardness setting.

• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling hole while

adding salt. Make sure that the salt reservoir lid is tightly closed after finishing the filling

process. Run the prewash programme to remove the salt that spilled inside the machine. Since

the salt granules that will remain under the lid will dissolve during prewash, causing the lid

loosen, check the lid once again at the end of the programme.

There is a different odour in the machine

A new machine has a peculiar odour. It will fade out after a couple of washing.

• Filters are clogged. >>> Check if the filter system is clean. Clean the filter system regularly

as illustrated in section “Cleaning and Care”.

• Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going to start the

machine right after you have put the dishes into it, remove the remnants on the dishes and run

the Prewash programme without detergent every 2 days. In such cases, do not close the door

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grundig GNI 41823 X Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Grundig GNI 41823 X

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info