• Press 9 / to open the cassette compartment.
• Insert the cassette.
• When monitoring during
recording, adjust the
sound using the controls
VOLUME and UBS.
These controls do not
affect the recording.
• Start recording by pressing 0.
(the A button is automatically also pressed).
– When the end of the tape is reached, the
recorder buttons are released.
• To interrupt recording, press
;.
• To continue recording, press
; again.
• Press 9 / if you want to stop recording
before the end of the tape.
On pressing again, the cassette compartment
will open.
• The set is switched off if the Function switch is
in position TAPE/OFF and no buttons are
pressed.
Power Supply
Mains operation ..................230 Volt, 50/60 Hz
Battery operation...8 x 1.5 V (R20, UM-1, ‘D’-cells)
Output power
Output power ......................................2 x 1 W
Headphone jack .....................ø 3.5 mm (stereo)
Radio section
Wavebands:......................FM 87.5 – 108 MHz
..................................MW 526 – 1606.5 kHz
Aerials:...........................Telescopic aerial for FM
..........................Built in ferrite rod aerial for MW
Cassette section
Cassette:............Compact cassette to DIN 45516
Track system:...................International quartertrack
Tape speed: .................................4.76 cm/sec.
Motor: ...............................................DC motor
Frequency range:.......................80 Hz – 10 kHz
Automatic functions: ..Automatic recording level control
....................Automatic button release at tape end
CD section
Frequency range:.......................20 Hz – 20 kHz
S/N ratio .......................................65 dB (wtd)
Accessories
....................................................Mains Cable
.................................................Warranty sheet
............................................Instructions for Use
General
Dimensions (W x H x D) .....390 x 180 x 240 mm
Weight (w/o batteries).................approx. 2.8 Kg
Subject to technical alterations and alterations in
styling E. and O.E.
Recording from the CD-player
(CD synchro recording)
• Set the Function switch to CD.
• It is not necessary to start the CD player
separately: by pressing 0 the CD player
starts automatically.
– If the CD player is in STOP position,
recording will start from the beginning of
the CD (or from the beginning of the
programmed selection).
• To start a recording in the middle of a
track, play the CD in the normal way.
• As soon as the desired passage is reached,
pause the CD and then start recording by
pressing 0.
Recording from the radio
• Set the Function selector to RADIO.
• Select the wave band using the BAND
switch.
• In case of FM radio recordings, set the
STEREO •• MONO switch to the desired
position.
• Tune to desired radio station using the
TUNING control.
• Start recording by pressing 0.
