Bedienungsanleitung Grundig WK 7280 (Seite 17 von 60) (Französisch, Spanisch, Polnisch, Türkisch)

570277

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

ENGLISH

Preparation

1 Clean kettle well before initial use and discard

the water of ﬁrst two boiling cycles.

Operation

1 Push the lid release button

on the kettle to

open the lid

2 Fill the water tank

with water.

Notes

Do not place the water tank

on the base

while ﬁlling it with water.

Never ﬁll the water tank

above the maxi-

mum level indicator or below the minimum

level indicator.

3 Close the lid

until it clicks into place.

4 Place the water tank

on the base

. Make

sure that it is sitting in an upright and stable

position.

5 Insert the plug into the wall socket.

6 Select the desired temperature by pressing the

selection button

. As the button

is pushed

the temperature selection will cycle from 100

to 80, 60, 40 and back to 100 again.

– The temperature indicator light

will ﬂash.

7 If desired, the simmer function can be acti-

vated by pressing button

– Indicator light of button

lights on.

Notes

When pressing the simmer function button

in stand by mode without selecting the desired

temperature, the indicator light of button

will

go off after 10 seconds.

8 Push On/Oﬀ button

– Indicator light of On/Oﬀ button

lights on

and the boiling process begins.

– When the appliance is in operation, indica-

tor light of the set temperature will ﬂash.

Meantime, current water temperature will

be indicated by the relevant temperature

indicator light until the set temperature is at-

tained.

Note

Lid

should always be closed during the boil-

ing process; otherwise the kettle will not switch

off automatically.

The desired temperature can be changed or set

during the boiling process by pressing tempera-

ture setting button

9 When the desired temperature is reached, the

indicator light of On/Oﬀ button

goes oﬀ

and the kettle stops operating.

– After 60 seconds the temperature indicator

lights

go oﬀ and the kettle returns into

stand by mode.

Notes

If you want to stop the boiling process manu-

ally, push the On/Off button

If the simmer function is activated, the kettle will

restart the boiling process when the tempera-

ture falls below the desired temperature. After

30 minutes, simmer function will be cancelled

automatically.

10 Disconnect the plug from the wall socket.

11 Take the water tank from the base

. Only

hold it by the handle

Caution

Do not open the lid

as hot water could

splash out. Make sure that no water splashes

onto the base

12 Pour the water from the spout

to the cup or

glass you want to use.

Note

Let the kettle cool down between each heating

process.

Hints and Tips

The kettle is equipped with a water filter

which filters out limestone and other residues

when the water is being poured out.

Use softened or filtered water to prevent lime

build-up.

OPERATION ______________________________

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grundig WK 7280 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Grundig WK 7280

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info