Bedienungsanleitung Grundig WK8680 (Seite 16 von 80) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Türkisch, Norwegisch, Finnisch)

711743

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

ENGLISH

Preparation

1 Remove all packaging and sticker materials

and dispose of them according to the applica-

ble legal regulations.

2 Before using the appliance for the ﬁrst time,

clean all parts which come into contact with

water carefully. (See the “Cleaning and care”

section).

3 Completely roll out the power cord from the

cable coil

on the bottom of the base

Pass the power cord through the slot on the

base.

4 Clean the kettle well before initial use and dis-

card water of ﬁrst two boiling cycles.

Operation

1 Push the lid release button

on the kettle to

open the lid

2 Fill the water tank

with water.

Notes

Do not place the water tank

on the base

while ﬁlling it with water.

Never ﬁll the water tank

above the maxi-

mum level indicator or below the minimum

level indicator.

3 Close the lid

until it clicks into place.

4 Place the water tank

on the base

. Make

sure that it is placed in an upright and stable

position.

5 Insert the plug into the wall socket.

― The actual temperature of water will be

shown on the display.

6 Set the water temperature to any desired value

(40-100) by pressing the temperature setting

button

(+/-).

7 Push On/Oﬀ button

.A warning beep will

be heard once. The button’s light will be on

during operation. Once the desired tempera-

ture is attained, the light disappears and the

operation is ﬁnished. You will hear 3 warning

(beep) sounds.

8 If desired, the simmer function can be activated

by pressing button

– Indicator light of button

lights on.

If the simmer function is activated, the kettle

will restart the boiling process when the tem-

perature falls below the desired temperature.

After 30 minutes, simmer function will be can-

celled automatically.

Warm-keeping button

operates in a range

from 50 °C to 90 °C.

Note

Lid

should always be closed during the

boiling process; otherwise the kettle will not

switch off automatically.

Note

If you want to stop the boiling process manu-

ally, push the On/Off button

9 Disconnect the plug from the wall socket.

10 Take the water tank from the base

. Only

hold it by the handle

Caution

Do not open the lid

as hot water could

splash out. Make sure that no water splashes

onto the base.

11 Pour the water from the spout

to the cup

or glass you want to use.

Hints and Tips

If you want to continue the boiling process, re-

peat the procedure from 1 to 10.

Let the kettle cool down between each heating

process.

The kettle is equipped with a water filter

which filters out limestone and other residues

when the water is being poured out.

Use softened or filtered water to prevent lime

build-up.

OPERATION ______________________________

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Grundig WK8680 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info