Bedienungsanleitung Gude 85056 (Seite 12 von 19) (Deutsch, Englisch)

628861

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Installation / first use

This appliance is equipped with a 40 cm gas hose for

connection – to ensure correct functioning, a pressure

regulator for 50 mbar on the cylinder is absolutely

necessary. We recommend the following pressure

regulators according to the purpose of use:

 Leisure time use – e.g. terrace, outdoors space, tent

vestibule, party tents etc., with adequate air in-take

and exhaust, pressure regulator 50 mbar

 For home use (any in-doors spaces) in compliance

with TRF1996-5.2.7.2 (amendment valid from the 1

June 2000) and for all industrial liquid-gas devices

(indoors and outdoors) in compliance with UW BGV

D34 section 11 par. 3 and 4: two-stage safety

pressure regulator ,,t" 50 mbar with pressure

gauge (not included).

Installation of the back cover - illustration 1:

To install the back cover, follow steps A, B and C:

A Turn the gas cylinder around until the opening points

outwards, to provide good access to the gas valve.

B Make sure the base of the gas cylinder is positioned

between the wheels support holder cubes.

C Install the back cover by placing the four hooks into

the openings in the protective cover.

Installation of the bottom - illustration 2:

(1) Take out the plastic button (E). Both cocks (C) of

the bottom part (B) must be fully inserted into the

back openings of the bottom (A) in the relevant

hollows (D).

Place the plastic button (E) you took out earlier into both

bottom openings (A) and (B).

Safety instructions – operation

General instructions for liquid gas cylinders handling:

Characteristics of liquid gas:

The liquid gas (propane, butane and their mixes) is a

highly flammable, colourless gas with strong smell. It is

heavier than air and it is flammable when mixed with even

a small amount of air.

Warning! Gas leaking without control can burst

into flame or explode.

The liquid gas in the cylinder is pressurized. Protect it from

temperatures over 40°C! Higher temperature, especially

due to fire, causes risk of uncontrolled gas leak and even

an explosion of the cylinder.

Malfunction procedure:

In case of malfunction and leaks (e.g. smell of gas, sounds

produced by leaking) follow these rules and guidelines:

 Turn the cylinder valve off immediately (clockwise).

 Do not smoke and no not use open fire.

 Do not turn any electric switch on or off.

 Do not make phone calls.

 Open doors and windows, ensure ventilation.

 If possible, carry the leaking cylinder outside of the

building.

 Leave the building and advise technical help of the

situation.

Safety prevention means:

 Touch protection at the device should prevent fire and

burns; no part of the protection can be taken off

permanently.

Full protection is not provided for children and ill

persons!

 The heating device is equipped with a low-oxygen

safety device. If a higher concentration of carbon

dioxide (CO2) is detected in the room, the safety

device will automatically shut the appliance off. The

appliance cannot be turned back on until the room is

ventilated properly.

 After use of the heating device, the cylinder valve

must be turned off!

Operation

After having read the general safety instructions and

the device-specific safety instructions and having

understood them, you can start operating the device.

Follow these instructions:

Installation of the gas cylinder:

 The device uses a mixture of propane and butane

under pressure of 50 mbar.

 To operate the device, a gas cylinder with liquid gas

of max. 11 kg of filling is necessary, the hose is pre-

installed.

 Gas regulator must be selected and/or purchased first

of all, depending on the purpose of use.

 Installation or change of cylinder with liquid gas must

be performed in non-flammable atmosphere.

 When the device is not in use and during change

of the cylinder, the device valve must be turned

off.

 The tightness must be checked at first use and during

each change of the cylinder, using a bubble-

producing means (e.g. soap water).

 Tightness is proven when no bubbles appear.

It is strictly forbidden to check tightness by open

flame!

 The cylinder must be placed in such a position so that

it is not in contact with the sheet metal of the burner

and the gas supply attached to it. The hose must not

touch (be in contact with) the hot back side of the

burner.

 The device is supplied with a 40 cm long hose. The

hose must not be shortened or exchanged for a

longer one.

 Inspect the condition of the hose regularly, at least

during each change of the cylinder.

 In case of damage to the hose, it must be replaced

with a hose of the same construction, tested

according to DIN DVGVV.

 Connection of the hose to the regulator must be done

with minimum of V4" left thread. The screw spanner

SW 17 is required for installation.

 Twisting or distortion of the gas hose during the

installation of the hose and pressure regulator to the

liquid gas cylinder is not permissible.

Warning! The hose must not touch (be in contact

with) the hot back side of the burner!

 Operation with pressure regulators other than those

prescribed above is prohibited.

 Make sure the hose and regulator are changed after

5 years at the latest.

Connection of the liquid gas cylinder:

 Take the protective cover of the valve off.

 Take the covering nut from the attachment socket off

by turning (right).

 Check the rubber seal in the cylinder valve (regulator

connection).

 The regulator and the hose must be screwed on

tightly (left thread). No not use any tool or instrument.

Do not turn the regulator but the sleeve nut.

 Check the tightness of the connection.

Change of the liquid gas cylinder:

 Close the cylinder valve

 Unscrew the regulator.

Gude 85056 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info