Bedienungsanleitung Gude 85101 GD 20 l (Seite 10 von 52) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

628923

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

persons are more sensitive to carbon monoxide than other

ones, e.g. pregnant women, persons with cardiac or

pulmonary diseases or anaemia, persons under the

influence of alcohol and persons at heights. Make sure you

have read all the maintenance instructions and have

understood them. Keep these Operating Instructions for

future reference. They are your guide for safe and

professional handling of this heating unit.

● Use only oil to prevent fire and risk of explosion. Petrol,

crude oil, paint thinners, alcohol and other highly

flammable fuels must not be used in any case.

Fuel:

a) Staff providing refuelling must be trained and fully

familiarised with the manufacturer's instructions and

applicable directives for safe refuelling of heating

units.

b) Only oil may be used for refuelling.

c) Any flame including the pilot flame must be blown out

to allow the heating unit to cool down before

refuelling.

d) Fuel lines and connections must be checked for

leaking when refuelling takes place. Any leaking must

be repaired before putting the heating unit back into

operation.

e) The maximum fuel daily dose should only be stored in

buildings near the heating unit. Large fuel reserves to

be stored outside the building.

f) All fuel storages must be at least 762 cm from heating

units, burners, welders and similar inflammable

sources (exception being a fuel tank integrated in the

heating unit).

g) If applicable, fuel storage should only be limited to

spaces where the flooring design prevents leaked fuel

accumulation and the fuel cannot catch fire as a

result of deeply stored inflammable sources.

h) Fuel must be stored in accordance with the local

official regulations.

General information:

 Never use the heating unit near petrol, paint thinners

or other easily combustible fumes.

 Follow all local provisions and regulations when using

this heating unit.

 Heating units used near reinforcement grids,

canvases or other coverings must be placed in a safe

distance from these materials. The recommended

minimum distance is 305 cm. Moreover, using

fireproof coverings is recommended. Fireproof

coverings must be safely attached to be protected

against catching fire and prevent heating unit being

touched and turned over due to wind gust.

 To be used in well ventilated spaces only. Before

putting the appliance into operation, make sure air

vent of at least 2,800 cm² for fresh external air is

provided for heating output of 100,000 BTU per hour.

 To be used in spaces with no flammable vapours or

high dust levels only.

 To be used at voltage and frequency specified on the

type label only.

 A properly earthed extension cable with a three-pin

plug to be used at all times.

 Minimum distance from flammable materials and

persons:

exhaust: 300 cm at sides, upper and rear side: 200

cm. (see pic. D)

 To prevent a risk of fire, the hot heating unit or

heating unit just being operated must be placed on a

safe and level surface.

 The heating unit must be transferred or stored in a

horizontal position to prevent fuel leaking.

 Keep children and pets in a sufficient distance from

the heating unit.

 Unplug the heating unit if not being operated.

 Never use the heating unit in residential rooms and

sleeping rooms.

 Never block the air inlet (rear side) and air outlet

(front side) of the heating unit.

 If the heating unit is hot, being operated or plugged, it

must never be transferred, handled, refuelled or

maintained.

 Do not fit any piping on the front and rear side of the

heating unit.

CAUTION:

Oil to be used only to prevent fire or explosion.

Using the appliance as a heat source for events

and parties or operating the appliance in stables is

strictly prohibited!

Use as designated

The GD-series oil hot-air turbine must solely be used for

heating and drying purposes in well ventilated spaces or

dry outdoor zones, in a safe distance from flammable

materials and other animals. It must be placed on a stable

and level surface when being operated. Only oil is allowed

to be used for refuelling.

(As far as safety, functionality and service life are

concerned, the GD series follows the latest criteria: the

safety equipment guarantees appropriate working of the

appliance; operating noise have been reduced to minimum

levels and the careful material selection makes it as much

reliable as possible.)

Assembly, pic. B

Description, pic. B

1. Handle

2. Screw

3. Wheel support frame

4. Hexagonal nut

5. Wheel

6. Cap nut

7. Axis

These models are supplied with wheels and handles.

Wheels, handles and appropriate parts for attaching are in

the box.

Necessary tools:

- medium-sized cross screw driver

- CH 8“ fork wrench or adjustment wrench

- hammer.

1. Put the axis through the wheel support frame. Mount

the wheels to the axis. IMPORTANT: When

assembling the wheels, the extended wheel hub must

point towards the wheel support frame (see picture

3).

2. Put a cap nut on each axis end and tighten it by light

hammer tapping.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gude 85101 GD 20 l Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info