621465
20
Zoom out
Zoom in
Vorherige Seite
1/76
Nächste Seite
16
GB
Résolution d’une panne
Defect Causes Measure
Compressor not starting after
being switched on
Pressure in the air jet exceeds the
closing pressure
Release the pressure in the air jet
so that the pressure switch gets
automatically switched on
Defective supply Have the current supply checked by
an authorised person
Defective pressure switch Have the pressure switch replaced
by an authorised person (Güde
service centre)
Worn carbons Replace the carbons
After reaching the closed pressu-
re, the compressor runs or buzzes
for a short time and then switches
o automatically
Electric cable is too long or its cross
section is too small
Check the length and cross section
of the electric cable
Compressor running constantly Suction lter is very dirty Clean or replace the suction lter
Pneumatic tools have high air
consumption
Check the pneumatic tool air
consumption;
seek an authorised compressed air
dealer
Leaking on the compressor Localise the leaking, contact the
Güde service centre
Compressed-air pipeline leaking Contact the Güde service centre
Drain valve is open or missing Close or insert the drain valve
Compressor gets started too often Too much condensate in the air jet Drain the condensate
Compressor is overloaded
Safety valve blowing o Pressure in the air jet exceeds the
set cut-o pressure
Have the pressure switch adjusted/
replaced by an authorised person
(Güde service centre)
Safety valve is defective Replace the safety valve or contact
the Güde service centre
Compressor getting warm too
much
Air supply is not sucient Make sure sucient air supply and
outlet (minimum distance from wall
is 40 cm) is provided
Cooling ns on the cylinder (cylin-
der head) are dirty
Clean the cooling ns on the cylin-
der (cylinder head)
Durée d’utilisation trop longue Switch the compressor o
Compressor being overheated
and keeps switching o
Compressor is overloaded Contact the Güde service centre
Compressor is defective Contact the Güde service centre
Compressor under undervoltage Contact the Güde service centre
Outdoor temperature of 35°C
ENGLISH
20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gude AIRPOWER 205-09-5 50093 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info