628919
26
Zoom out
Zoom in
Vorherige Seite
1/56
Nächste Seite
6
GB
TROUBLESHOOTING
Continued
FAULT CONDITION POSSIBLE CAUSE REMEDY
Heater ignites but ignition control
assembly shuts heater off after a
short period of time (ON/OFF switch
light remains on)
1.Pump pressure incorrect
2. Dirty air intake, air output, and/or lint
lter
3.Dirty fuel lter
4. Obstruction in nozzle assembly
5. Photocell assembly not properly installed
(not seeing the ame)
6. Dirty photocell lens
7. Bad electrical connection between
photocell and ignition control assembly
8. Defective photocell
9. Defective ignition control assembly
1. See Pump Pressure Adjustment, page 8
2. See Air Output, Air Intake, and Lint Filters,
page 8
3. See Fuel Filter, page 6
4. See Nozzle Assembly, page 8
5. Make sure photocell boot is properly
seated in bracket
6. Clean photocell lens
7. Check electrical connections. See Wiring
Diagram, page 17
8. Replace photocell
9. Replace ignition control assembly
ON/OFF switch light does not come
on when switch is turned to the ON (|)
position and heater does not start
1. No power to heater
2. Bad electrical connections
3. Electrical short in ignitor
1. Verify that power cord is plugged into an
electrical outlet and that the circuit breaker
in the electral panel is reset
2. Check electrical wiring and connections.
See Wiring Diagram, page 17
3.Check ignitor wiring. If no problems are
found, replace ignitor (see page 7)
ON/OFF switch light comes on when
switch is turned to the ON (|) Position
but turns off after ve seconds
1. Electrical short in motor 1.Check motor wiring. If no problems are
found, replace motor
WARNING: High voltage!
WARNING: High voltage!
SERVICE PROCEDURES
WARNING: Never service heater while it is plugged in,
operating, or hot. Severe burns and electrical shock can
occur.
UPPER SHELL REMOVAL
1. Remove screws and lock washers along each side of heater
using 5/16” nutdriver. These screws attach upper and lower
shells together.
2. Lift upper shell off.
3. Remove fan guard.
FUEL FILTER
(35.000 and 70.000 Btu/Hr Models)
1. Remove side cover screws using 5/16”nutdriver.
2. Remove side cover.
3. Pull rubber fuel line off fuel lter neck.
4. Carefully pry bushing and fuel lter out of fuel tank.
5.Wash fuel lter with clean fuel and replace in tank.
6.Attach rubber fuel line to fuel lter neck
7.Replace side cover.
FUEL FILTER
(100.000 Btu/Hr Models)
1. Remove side cover screws using 5/16”nutdriver.
2. Remove side cover.
3. Pull upper fuel line off fuel lter neck.
4. Carefully pry bushing, lower fuel line, and fuel lter out of fuel
tank.
5. Wash fuel lter with clean fuel and replace in tank.
6. Attach upper fuel line to fuel lter neck.
7.Replace side cover.
Continued
TROUBLESHOOTING
SERVICE PROCEDURES
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Gude GD 10E 85090 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info