Bedienungsanleitung Gude SET 380-10-50 KR 15 TLG - 71175 (Seite 15 von 57) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

621532

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

Fault Cause Remedy

Pressure in the air receiver is higher than switch-

on pressure

Release the pressure from the air receiver so

that the pressure switch switches automatically

Faulty feeding Have the power feeding checked by an

authorized person

Circuit breaker of the motor interrupts the power

feed

Compressor does not start

after switching on

Faulty pressure switch Have the pressure switch replaced by an

authorized person

B Compressor shortly starts or

buzzes at the reach of the

switch-on pressure and then

switches off automaticall

Electric cable is longer than permitted or is of too

small cross-section

Check the length and cross-section of the

electric cable

Suction filter is contaminated heavily Clean or replace the suction filte

Pneumatic tool has too high air consumption Check the air consumption of the pneumatic

tool; contact authorized reseller

Leak at the compressor Locate the leak, notify Güde service

Too much condensing water in air receiver Drain the condensing water

Leaky pneumatic piping Check the pneumatic piping, seal the leak

Compressor runs without stop

Mud-discharge valve is open or missing Close or insert it

D In operation the relief valve

under the pressure switch

releases the pressurized air

Leaky relief valve Clean or replace the relief valve

Insert of the non-return valve is leaky or

faulty

Clean or replace the insert of the non-return

valve

After switch-off pressure is

reached the relief valve under

the pressure switch releases the

pressurized air until the switch-

on pressure is reached

Non-return valve is damaged Replace the non-return valve

Too much condensation water in the air

receiver

Drain the condensation water F

Compressor switches on

frequently

Compressor is overloaded

Pressure in the air receiver is higher than set-up

switch-off pressure

Have the pressure switch readjusted /replaced

by an authorized person (Güde Service)

G Safety valve blows off

Safety valve is faulty Replace the safety valve or contact Güde

Service

Intake air is insufficient Make sure that sufficient intake and outlet of the

air is guaranteed (minimum distance from a wall

40 cm)

Cooling ribs at the cylinder (cylinder head) are

dirty

Clean the cooling ribs at the cylinder (cylinder

head)

H Compressor heats too much

Too long period of use Switch off the compressor

Condensation water accumulates in oil Compressor is overdesigned, notify the Güde

Service

I The oil level rises without oil

being added

High air humidity Replace the oil

J Compressor is overheated and

it switches off

Compressor is overloaded

Notify the Güde Service

Compressor is faulty

Notify the Güde Service

Compressor has under voltage Notify the Güde Service

Ambient temperature 35°C

Notify the Güde Service

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gude SET 380-10-50 KR 15 TLG - 71175 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info