Bedienungsanleitung Gys NEOSTART 320 (Seite 8 von 32) (Deutsch, Englisch, Holländisch, Französisch, Spanisch)

625745

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

NEOSTART 320 / 420 / 620

USE IN STARTING MODE

Precautions before use

• Do not disconnect the battery from the vehicle. Disconnecting the battery may result in loss of information and a

possible inability to restart.

Starting

Once you have connected the starter to the battery as recommended (see connection), it may be necessary to precharge

the battery to provide the energy needed for starting. To perform a precharge turn the switch on the "BOOST 2" position

for the NEOSTART 320 and on the "BOOST" position for the NEOSTART 420 and 620.

NEOSTART 320 :

Instantaneously 5 min precharge

Neostart

320

12 V 35 - 60 Ah 60 - 120 Ah

24 V 35 - 45 Ah 45 - 90 Ah

NEOSTART 420 and 620 :

Instantaneously 5 min precharge

Neostart 420 35 - 80 Ah 80 - 160 Ah

Neostart 620 45 - 100 Ah 100 - 200 Ah

To perform the precharge set the switch to the "BOOST" position.

To start a vehicle turn the switch to the "START" position. Go to the vehicle driver side. By turning the key you activate

the starter function. This function must be stopped as soon the vehicle start. It is ideal to work with two people. The

one close to the NEOSTART can turn the switch to the START position at the last moment and stops the device once

the vehicle has started.

If your engine does not start, wait 2 minutes between two start attempts. The attempt must last a maximum of 3 sec.

Nb: A vehicle that will not start can be a problem other than a battery in poor condition. It could come from many other

causes.

After use follow the recommended instructions for disconnection.

PROTECTION

This device has been designed with maximum protection:

• The charging clamps are fully insulated.

• A fuse provides proctection against reverse polarity and short circuits :

- Neostart 420 and 620 : ref. 054547, 200A fuse (SIBA-V Fuse / open type)

- Neostart 320 : ref. 054639, 150A fuse (Littlefuse BF1 / 32V type)

• A circuit breaker on the front panel provides protection against overload or starting the battery with the switch on the

"Charge" position. If it breaks, a manual reset is required.

• Thermal protection is provided by a thermostat (cooling approximately 1/4h). The green light goes off in case of

overheating.

SULPHATED OR DAMAGED BATTERIES

NEOSTART does not detect sulphated or damaged batteries.

• Your battery is deeply damaged if in charge, the ammeter needle deects rapidly to very high intensities. Your battery

is permanently out of use.

• In the case of a sulphated battery: turn the device on the highest speed "BOOST" for the NEOSTART 420 and 620

or "BOOST 2" for the NEOSTART 320 and regularly monitor if the ammeter shows a charging current. As soon as the

charging current increases, put the switch onto the suitable charging mode for the battery. If there is no improvement

after 5 hours, the battery is permanently out of use.

Caution - This procedure must be done with the battery disconnected from the vehicle!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Gys NEOSTART 320 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info