701205
14
Zoom out
Zoom in
Vorherige Seite
1/98
Nächste Seite
4) Remove the heat exhaust hose assembly, clean and keep it properly.
Notes
:
H
old the exhaust hose assembly with both hands when removal.
Push the fasteners aside on exhaust air outlet using your thumbs, then pull out exhaust hose
assembly.
5) Pack the air-conditioner properly with soft plastic bag and put it in dry place with appropriate
dust-proof measures, and keep the unit away from children.
6) Take out the batteries from the remote control and keep it properly.
Note:
Assure the unit is stored in a dry place. All accessories of the unit shall be protected together properly.
Tr
oubleshooting
Please check the unit and suggestions below before asking for professional service, but never
dismantle or repair the unit by yourself, it may cause harm to you and your property.
Trouble Cause Remedy
The unit fails to
start up
Power supply failure
Connect the unit to a live socket and
turn it on.
Water-full and its icon lighting Drain the water stored in the unit.
Ambient temperature too low
or low high
It is recommended to use this unit
between 7-40
The room temperature is lower
than the set temperature in
cooling mode or higher
temperature in heating mode
Change the set temperature
Bad cooling
effects
There is direct sunlight Close the window curtain
The doors and windows are
open, the room is crowded or
there are other heat sources
Close the door and window, remove
other heat sources, and add new
air-conditioners
Dirty filter Clean or replace the filter mesh
Air inlet or air outlet clogged Remove the obstruction
High noise level
The unit is being placed at
uneven surface.
Put the unit at a flat and firm place
(may reduce noise)
The compressor
does not work
Initiation of overheat
protection.
Wait until the temperature decrease,
the unit will re-start automatically
The remote
control does not
work
Too long distance
Bring the remote control close to the
air-conditioner and ensure airs at
signal receptor on unit.
The remote control didn’t aim
at signal receptor on unit.
The batteries have no
electricity
Replace the batteries
CH01” code
displays
Room temperature sensor
failure
Check the room temperature sensor
and related circuits
CH02code
displays
Tube temperature sensor
failure
Check the tube temperature sensor
and related circuits
“E4” code
displays
Anti-freeze protection
Restore the functions automatically
once anti-freeze protection is over.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für H.Koenig KOL6012 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info