472094

H2o X5 Seite 13

13
Zoom out
Zoom in
Vorherige Seite
1/13
Nächste Seite
10
1
45º
2
3
4
Ensure that the Steamer Appliance is unplugged. Turn the Water Tank Cap
counter-clockwise to the “OPEN” (unlock image) position and remove the Water
Tank Cap as shown in illustration 1. Angle the Steamer Appliance as shown in
illustration 2 and add water with the Measuring Cup or similar cup. Do NOT overfill
or add water directly from a faucet, hose or the like. The Water Tank capacity is
400ml/13.5 oz. Replace the Water Tank Cap into the hole on the Water Tank and
turn clockwise until the blue dot on the Water Tank Cap aligns with the “CLOSE”
(locked image) position as shown in illustration 3. Make sure the Copper Cone
inside the Water Tank is always submerged in the water (see illustration 4) while
operating the Steamer Appliance.
HOW TO USE THE
H2O MOP
®
STEAMER APPLIANCE
!
IMPORTANT
• Never put hot water or any other liquids (including alcohol-based), additives,
detergents, cleaners and the like (regardless of temperature) in this Steamer
Appliance’s Water Tank. Doing so will make operation unsafe and damage this
Steamer Appliance.
• Unless approved by the manufacturer, do NOT put any scented products in the
Water Tank.
• The Steamer Appliance uses tap water, but in areas with hard water use distilled
water for better performance.
LOW STEAM
FOR SENSITIVE SURFACES
• Garments
• Mattresses & Pillows
• Upholstery
• Sealed Hardwood/Laminate
(may also use medium
steam setting)
MEDIUM STEAM
FOR LIGHT CLEANING
• Plastic
• Granite & Marble
• Tiles
• Slate
• Windows & Mirrors
HIGH STEAM
FOR TOUGHER STAINS
• Stainless Steel
• Porcelain Fixtures
• Carpets & Door Mats
HOT SPRAY
FOR SCRUBBING
• Concrete
• Toilets
• Sinks
• Rims
Select one of the Steam Regulator positions
FILLING THE TANK
11
HOW TO USE THE H2O MOP
®
STEAMER APPLIANCE – FLOOR MOP
Once completely assembled and filled with water, plug the Power Supply Cord into
a grounded electrical outlet. The LED ON/OFF Light should show RED indicating that
electrical power is available and the Steamer Appliance is then ready to be turned
ON and OFF.
• If the Power Switch is pressed ON before the LED ON/OFF Light has turned from RED
to GREEN, water remaining from the previous use will be forced out because there
has not been sufficient heating time to convert it to steam. This can or will cause
small water “puddles” on the adjacent surface.
• Small water puddles may also occur if the Steamer Appliance was unplugged from
the power outlet before being properly turned OFF with the Power Switch.
• Always make sure to use the Power Switch to turn the Steamer Appliance OFF after
each use before unplugging the Power Supply Cord from the electrical outlet.
!
IMPORTANT
Floor Mop Cleaning Tips
• Slowly pass over the surface to be cleaned with a steady controlled pace. The goal is
to allow the absorbent Microfiber Cloth to pick up the dirt loosened by the steam.
• Apply steam as needed using the Steam Regulator Dial and the suggested settings
contained in this manual. As a general rule less steam is better for most cleaning
jobs because of the concentrated focus. This is especially true for surfaces that you
want to leave clean and dry.
• When and if the Steamer Appliance stops producing steam when the Power Switch
is ON, it typically means that the Water Tank needs to be refilled. In such instances,
you still must turn the Power Switch to the OFF position, unplug the Steamer
Appliance as described and follow the instructions for refilling the Water Tank
contained in this manual.
Turning the Steamer Appliance ON:
Step 1 - Once plugged in, the LED ON/OFF Light should
remain RED for approximately 20-30 seconds. Do NOT
push the Power Switch while the LED ON/OFF Light is RED.
Step 2 - Wait for the LED ON/OFF Light to turn GREEN
indicating that the Steamer Appliance is ready for use.
Step 3 - Once the LED ON/OFF Light has turned GREEN, press the Power Switch to
ON (I). Within a few seconds the Steamer Appliance should start emitting steam.
Turning the Steamer Appliance OFF:
Step 1 – To turn the Steamer Appliance OFF simply press the Power Switch to the
OFF (O) position once. Almost immediately the steam will cease emitting from the
Steamer Appliance.
( O / I )
… 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

h2o-x5

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für H2o X5 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von H2o X5

H2o X5 Bedienungsanleitung - Holländisch - 19 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info