Bedienungsanleitung Haas-Sohn DK Lausitz - Easy (Seite 4 von 8) (Englisch)

811928

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

3.2. The draft of the chimney at nominal heating output of the stove.

min. draft of the

chimney

12 Pa

If the minimum draft of the chimney is not achieved, a proper

operation of the stove is not possible.

At a low draft of the chimney, we recommend to connect

the chimney by a vertical tube, 1 m long at least.

max. draft of the

chimney:

20 Pa

If surpassing the maximum admissible draft of the chimney,

there increases the consumption of fuel, the temperature in the

combustion space and consequently, the heating output.

There arises the danger of overheating, and consequently,

excessive load on construction parts.

In case of excessive draft of the chimney, we recommend

to install a draft controller or a draft limiter.

3.3. Connection to the chimney

The tube of the smoke flue must be mounted on the neck of the discharge of combustion products.

The tube of the smoke flue must not be installed with a gradient towards the chimney.

There must be paid attention unconditionally that the tube of the smoke flue may not protrude into

clear diameter of the chimney; it would disturb the upward lift of the combustion products and would

make an optimum cleaning of the chimney more difficult.

Longer horizontal sections of smoke flue tubes reduce the necessary draft of the chimney.

Al the orifices mouthed into the same chimney, such as cleaning orifices of the stove and of the

chimney, must be shut.

In case of multiple employment of the chimney, the minimum vertical distance of two chimney

connections ought to be 30 cm at least. As a matter of principle, the fire places must be suitable

and approved for multiple employment of the chimney.

4. Emplacement

4.1. Minimum distances from inflammable construction parts:

As a matter of principle, the emplacement of a fireplace stove must observe the valid official fire-fighting

regulations.

In this respect, please observe the international regulations.

Caution! As minimum distances from inflammable materials or materials sensitive to heat (e.g. furniture,

wallpapers, wooden linings), or load-bearing walls respectively, there must be respected the distances shown in the

type plate.

In case of inflammable floorings or the flooring sensitive to heat, the appliance must be placed on an incombustible

floor plate (e. g. a glass panel) (see the drawing).

Caution! With a stove with lateral window, the same distance must be maintained as with the extent of

radiation in the front!

Recommended protection of the floor

A 50 cm –in the front

C30 cm – from the inside edge of the combustion space

120 cm –extent of radiation from the window

Safety distances from inflammable construction parts:

In the rear: - see the type plate

On the side: - see the type plate

In the front in the extent of radiation: see the type plate

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haas-Sohn DK Lausitz - Easy Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Haas-Sohn DK Lausitz - Easy

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info