Bedienungsanleitung Haas-Sohn ESPRIT-IV (Seite 10 von 12) (Englisch)

811881

Zoom out

Zoom in

Vorherige Seite

1/12

Nächste Seite

Caution! Wood it not a slow-burning fuel so that

continuous heating of the fireplace with fuel

overnight is not possible.

The fireplace insert is intended for the burning of

dry billet wood with a maximum water content of

30% of the dry weight. Billet wood should be

stored in airy and dry places for 2 years.

Excessively moist wood increasingly results in

smouldering with tar and condensate formation

which can damage the chimney. At any rate,

excessive device contamination occurs. The billet

wood length should be around 33 or 50 cm.

If incorrect or excessively moist fuel is used a

chimney fire can occur because of deposits in

the chimney. Immediately close all air

openings in the stove and inform the fire

brigade. Once the chimney has burnt out have

it inspected for cracks or leaks by an expert.

Wood is a highly de-gassing fuel and requires a lot

of top air (secondary air). Light or slow-burning

control with this fuel is not possible. The heat

output in the combustion of wood is always

determined by the amount charged.

Firing of properly dried wood is the most

economical and most environmentally friendly

combustion since the calorific value of fresh wood

is substantially less than that of dry wood.

The burning of waste, especially plastic, packaging

material, coated and treated wood harms your

fireplace insert and is additionally prohibited by the

Federal Emission Protection Law. Brush wood,

paper and small wood pieces must only be used

for lighting.

Caution: Never use easily combustible liquids

such as petrol, spirits for lighting and always

keep such liquids away from your fireplace

insert.

10.2 Combustion air supply:

With both the open and closed operation of the

fireplace carries a high demand for fresh air. Do not

change existing precautions for combustion air

supply. Ensure that the necessary combustion

airlines are open while the fireplace is operated.

10.3 Convection air:

To avoid heat congestion the convection air inlet

and outlet grilles must always be open during

heating operation.

10.4 Fire protection outside the radiation

range:

No objects of combustible building materials (e.g.

shelves) must be placed closer to the open fireplace

than a distance of 5 cm.

10.5 Fire protection within the radiation range:

Seen from the firebox opening forward and to the

sides, no combustible components must be

present (e.g. furniture, carpets, flowers etc.) in a

range of at least 80 cm.

10.6 Protection against burns:

It is imperative to note that there are hot surfaces or

operating handles present on heating devices which

are in operation. Please use the enclosed protective

glove to operate the fireplace. Presence in the 80

cm radiation range is only advisable to charge the

fuel, prolonged presence there can result in skin

burns. Keep children away from fireplaces in

operation.

When operating the device ensure that adequate air

is supplied to the room from the outside.

11. Use and start-up:

11.1 Initial start-up:

When using the fireplace insert for the first time

burn it with moderate output to avoid possible

damages due to heating it up too quickly

(especially drying of the refractory brick lining). On

initial heating, smell and smoke will develop due to

the curing of the surface coating. Ensure the room

is well ventilated during initial start-up.

11.2 Lighting:

The fireplace insert is charged with fuel through

the firebox door.

Initially place 3 to 4 wood billets (approx. 2.0 to 2.5

kg) on the firebox floor or grate, uncoated paper on

top, cardboard or an igniting cube, brushwood,

small wood pieces or briquette pieces on top of

this. Open all existing air control dampers to the

maximum. After igniting, close the firebox door.

Then set the air control dampers in accordance

with the instructions on the enclosed Equipment

Sheet.

Your fireplace insert is equipped with a typical

design flat firing system which means that only one

layer of fuel must be charged on the basic embers.

Please note that the quantity, the size of the

pieces and the kind of the wood charged has a

direct influence on the heat output.

When feeding excessive fuel quantities your fire

insert can be heated in excess of what is intended

by the design. This can damage the fireplace

insert, other parts of the chimney of the building

itself. Never charge more than the stated fuel

quantities at one time on the existing basic

embers.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haas-Sohn ESPRIT-IV Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Haas-Sohn ESPRIT-IV

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info