Bedienungsanleitung Haier HAKWBD 60 (Seite 10 von 132) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch)

817810

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

Setting The Temperature Controls

•When pressing “ ” or “ ” button, the system will be entering the set up mode in the upper or lower

compartment automatically. The LED will start flashing and display the actual temperature.

Press once the button, the temperature will decrease or increase 1 ℃. When exceeding the minimum value that

can be established, it will jump to the highest adjustable temperature value automatically. After stopping pressing

the button for 5 seconds, LED figure will stop flash, then revert back to display the temperature of the upper or

lower compartment.

After the unit is unplugged, the system will return to the acquiescence temperature, which is set by the

factory. The acquiescence temperature is as below:

Upper compartment: 6 ℃

Lower compartment: 12 ℃

Upper compartment: The temperature setting can be adjusted from 5℃ to 10℃.

Lower compartment: The temperature setting can be adjusted from 10℃ to 18℃.

Temperature Alarm

If the temperature inside is higher than 23 ℃, it will display "HI" on the display panel, and after one hour after the alarm / buzzer

will sound. This indicates that the temperature inside is too high. If the temperature inside is lower than 0 ℃, it will display "LO"

on the display panel and at the same time the alarm also malfunction indicator is active.

Temperature Recollection Function

In the event of a power interruption, wine chiller can remember the previous temperature settings, and when the power

is recovery, the cooler temperature will go back the same setting temperature as power off.

Overtime Open the Door Alarm

When you forget close the door or the door is not closed completely, the buzzer alarm after 5 minutes. Please close the

door completely and avoid the cold energy was lost.

Internal light

In order to reduce energy consumption, the LED light within this wine cabinet will automatically switch off when

closed the door. If you would prefer the LED light to remain on continuously, this is possible. Please press and hold

the “LIGHT” bottom for 5 seconds, the display will show “LP”. After 4 seconds the display will revert back to normal

and the light will remain on until manually switched off.

If you would like to revert back and conserve energy (recommended), press and hold the “LIGHT” button for 5

seconds, the display will show “LF”. After 4 seconds the display will revert back to normal

the light will be on when door open and the light turn off when door closed.

Replaceable (LED only) light source by a professional

This product contains a light source of energy efficiency class G.

If you want to display each actual indoor temperature, press the corresponding button " Set Upper " or " Set

Lower ", and the LED will flash and display the current temperature. After you stop pressing the button for 5

seconds, the LED figure will stop flashing, then revert back to show the set temperature.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haier HAKWBD 60 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info