710920
25
Zoom out
Zoom in
Vorherige Seite
1/384
Nächste Seite
GB
9- Troubleshooting
Problem Possible Cause Possible Solution
The compressor
does not work.
Mains plug is not connected in the
mains socket.
Connect the mains plug.
The appliance is in the defrosting
cycle.
This is normal for an automatic
defrosting.
The appliance runs
frequently or runs
for a too long pe-
riod of time.
The indoor or outdoor tempera-
ture is too high.
In this case, it is normal for the ap-
pliance to run longer.
The appliance has been o power
for a period of time.
Normally, it takes 8 to 12 hours for
the appliance to cool down com-
pletely.
A door/drawer of the appliance is
not tightly closed.
Close the door/drawer and ensure
the appliance is located on a level
ground and there is no food or
container jarring the door.
The door/drawer has been opened
too frequently or for too long.
Do not open the door/drawer too
frequently.
The temperature setting for the
freezer compartment is too low.
Set the temperature higher until a
satisfactory refrigerator tempera-
ture is obtained. It takes 24 hours
for the refrigerator temperature
to become stable.
The door/drawer gasket is dirty,
worn, cracked or mismatched.
Clean the door/drawer gasket or
replace them by the customer
service.
The required air circulation is not
guaranteed.
Ensure adequate ventilation.
The inside of the
refrigerator is dirty
and/or smells.
The inside of the refrigerator
needs cleaning.
Clean the inside of the refrigera-
tor.
Food of strong odour is stored in
the refrigerator.
Wrap the food thoroughly.
25
9.1 Troubleshooting table
Many occuring problems could be solved by yourself without specic expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
Electrical equipment should be serviced only by qualied electrical experts, because
improper repairs can cause considerable consequential damages.
A damaged supply should only be replaced by the manufacturer, its service agent or
similarly qualied persons in order to avoid a hazard.
25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Haier HB16FMAA wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Haier HB16FMAA

Haier HB16FMAA Bedienungsanleitung - Holländisch - 34 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info