Bedienungsanleitung Haier hdy c70 e (Seite 5 von 9) (Englisch)

303415

Zoom out

Zoom in

Vorherige Seite

1/9

Nächste Seite



A - Program selector

Turn this knob to choose the drying program you desire. This type of dryer

has 11 program options . For description of specific programs, refer to the list of

programs on Page 10. When the drying program is selected,the relevant indicator

light is on.

B - Start/Pause button

Gently touch this button to start the dryer. Gently touch this button again

during the operation of the dryer and the indicator light and display screen will

flash and the machine will be paused .Press the button again and the program

will continue .

C - Signal button

When the drying cycle has finished, an intermittent acoustic signal will

sound.Touch this button,the buzzer will be canceled.

F- Delay button

Gently touch this button before the program starts. You may choose to start

the dryer after a preset time. The delay range is between 1 and 19 hours.

Every touch of the delay button will increment by one hour. When you pass 19

hours, the delay time will turn off. After a delay time is set, gently touch the

Start/Pause button to the start the delay operation and the indicator light will

flash.



D+E composite button and child lock function

During a program, press and hold down both buttons for 3 seconds to

set up the child lock function if necessary. At this time, The display screen

shows the remaining time and the lock alternatively, and the control panel will

lock. Press and hold down both buttons for 3 seconds once again and the child

lock will release.When the program ends or during a power failure the child lock

will release.

H - LED screen

The screen displays the remaining time for a program, the delay time and

other related information.

Note: The remaining time to start a program is the default time for the

program. During operation, with variation of factors such as

the moisture

content. The actual remaining time will be automatically adjusted

until the preset

drying result has been achieved and the program is complete.

'()

E - Delicate button

During this program, the drying temperature and power will decrease and

the

drying time will increase to take better care of the delicate laundry.

D- Anti-crease button

If this additional function is selected, the anti-crease phase at the end of

the drying cycle is lengthened by 60 minutes. The laundry can be removed

at any time during the anti-crease phase.

G - Programme progress display

Depending on the programme selected, the drying stage reached is

shown by the indicator lamps on the control panel:

- Drying

- Ready to iron

- Airing

- End/Anti-crease

At the end of a programme,the End/Anti-crease indicator lamp comes on.

The drum will continue to rotate at intervals to prevent laundry creasing, if you

do not wish to remove it immediately.

I - Maintenance displays

- Empty tank

- Clean filter

- Clean condenser

Important: After each drying cycleˈ

– Clean the filter˗

– Drain the condensed water container˗

(See section “Cleaning and maintenance”)

Control panel Control panel

J -Power button

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haier hdy c70 e Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info