Bedienungsanleitung Haier HW60-B1286 (Seite 20 von 23) (Englisch)

711349

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

WATER INLET VALVE AND INLET VALVE FILTER

To prevent blockage to the water supply by ingress of foreign substances, clean the water inlet valve and

inlet valve ﬁlter regularly

MOVING THE MACHINE

MAINTENANCE OR SERVICE WASH

If the machine is to be moved to a distant location, replace the transportation bolts

removed before installation to prevent da

mage as

shown below

Remove the back cover1.

Remove the blanking plugs.

Insert the synthetic stabilisers and the transportation bolts.3.

Tighten the bolts with a spanner .4.

Replace the back cover

LONG PERIODS OF DISUSE

If the washing machine is left idle for a long period, pull out the electrical plug and turn off the water supply．

Open the was her door to

prevent formation of moisture and odours. Let the door open while not used.

Delay

Power

Heavy

Sport wash

Quick

Spin

Wash

Rinse

Spin

Temp.

Speed

Auto

Silk

Wool

Synthetic

Memory

Cotton

Start/Pause

Pressand hold 2seconds

to set door unlocked

Delicate

Silent

Self-clean

Strongwash

Pre-wash

Soak

MANUALLY OPENING THE WASHING MACHINE DOOR

To add clothing when washing after the wash program has started or after a power cut, you want to remove the

clothing, do the following steps.

1. Make sure the level of water in drum must under the lowest edge of the door window,

2. The temperature of water is not over 50°C

3. The machine is switch off at the power supply so the drum cannot turn.

4. Disconnect the drain hose and place the open end in a bucket lower the end so that the

water in the washing machine drains out.

5. Re-connect the drain hose to the drain system.

6. Open the ﬁlter access door at the bottom of cabinet, you can see a ring pull handle. Gently pull the sprung loaded

handle down, and pull the door at the same time to open it.

7. You can add or remove the clothing. Caution, the clothing will be very wet.

8. Close the ﬁlter door.

A maintenance wash is recommended to be done to clean the washing machine out by running a high-temperature (90°C Cotton)

program. This is especially recommended if you do a signiﬁcant number of low temperature washes a month. The high temperature

kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves putting the washing machine on the hottest

wash (90°C Cotton Wash) with only the detergent inside - and no laundry. If you normally use a washing machine detergent that

doesn't contain bleach, then buy some detergent that does, and use it for your maintenance washes. This will help kill off bacteria

and prevent black mould and grease. Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach

(like Domestos) in the washing machine this will damage the machine. There are certain types of bleach example oxygen bleaches

like “Vanish” that are appropriate for laundry. To check if your washing machine is being badly affected, carefully examine the inside

of the door seal for slime. Pull the lip in front of the drum and look underneath on lip of the tub as it can accumulate a slime, which

causes smells, and rots the seal.

USING THE APPLIANCE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haier HW60-B1286 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info