Bedienungsanleitung Haier Jade serie (Seite 16 von 73) (Deutsch, Englisch, Französisch, Italienisch, Portugiesisch, Spanisch)

771619

Zoom out

Zoom in

Vorherige Seite

1/73

Nächste Seite

1. Insert from outside the room cable into left side of the wall

hole, in which the pipe has already existed.

2. Pulloutthe cableonthe front side, and connect the cable

making a loop.

outdoorunits carefully. If wiring is not correct, properoperation can not

Insert the cable from the back side of the unit, then pull it out on the front side.

Loosen the screws and insert the cable ends fully into terminal block, then

tighten the screws.

Pull the cable slightly to make sure the cables have been properly inserted and

tightened.

After the cable connection, never fail to fasten the connected cable with the

wiring cover.

When connectingthe cable afterinstallingtheindoor unit

When connectingthe cable before installing the indoor unit

Note:

1. If the supply cord is damaged, it must be replaced by the manufacturer or its

H05RN-F or H07RN-F.

2. If the fuse on PC board is broken please change it with the type of

3. The wiring methodshould be in line with thelocal wiring standard.

4. Afterinstallation, thepower plugshould be easilyreached.

all-pole switch andthedistance between its two contacts shouldbenotless

than 3mm.

T.3.15A/250VAC (Indoor).

To Outdoor unit

Connecting wiring

4G1.0mm

C od e

indication Trouble description A nalyze and diagnose

E14

H ea t-exc hange

sensor failure

Indoor EEPR O M

error

C om m unication

fault betw een

indoor and outdoor

units

Indoor fan m otor

m alfunctio n

Operation halt due to breaking

of wire inside the fan m otor;

Operatio n halt d ue to break in g

of the fan m otor lead w ires;

D ete ction e rro r due to faulty

indoorunit P C B ;

Indoorunit- outdoor unit signal

transm issio n e rro r du e to w iring

error;

Faulty P C B ;

F au lty E E PR O M da ta;

Faulty EEPR O M ;

F au lty P C B ;

Faulty connector connection;

Fa ulty therm istor;

Faulty P C B ;

Room temperature

sensor failure

The power source must be exclusivelyused for airconditioner.

In the case of installing an air conditionerin a moistplace, pleaseinstall

an ea

For installation in other places, use a circuitbreaker as faras possible.

Pipe cutting is carriedout with a pipe cutter andburs must be removed.

Power Source Installation

CuttingandFlaring Work of Piping

Clutch-type clutch-type(Rigid-type) Wing-nut type (Imperial-type)

A 0~0.5mm 1.0~1.5mm 1.5~2.0mm

rth leakagebreaker.

Lean

tcerrocnItcerroC

On Drainage

It becomes

high midway. The gap withthe

ground is too small.

Thereisthebad

smell from a ditch

It waves.

Theend is imm-

ersed in water.

Please install the drain hose so as to be downward slope without fail.

Pleasedon’t do the drainage as shown below.

Please pour water in the drain pan of the indoor unit, and

is carried out surely to outdoor.

In case that the attached drain hose is in a room, please applyheat

insulation to

Lessthan

5cm

drainage

it withoutfail.

Crack

Indoor unit

Check Itemsfor Test Run

Gas leak from pipe connecting?

Heat insulation of pipe connecting?

Is drainage securely carried out?

Is theearth linesecurely connected?

Is power source voltageabidedbythe code?

Is there any noise?

Is the lampnormallylighting?

Are cooling and heating (when in heat pump) performed normally?

Is the operation of room temperature regulator normal?

Please kindly explain to our customers how to

operate through the instructionmanual.

inserted to the terminalblock?

Put check mark in boxes

Flare toolingdie1.Cut pipe 2.Remove burs

4.Flare pipe

On Drainage

Check for Installation and Test Run

AS25JBJHRA-W

4G1.5mm

AS35JBJHRA-W

AS50JDJHRA-W

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haier Jade serie Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Haier Jade serie

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info