Bedienungsanleitung Haier Jade Supermatch (Seite 20 von 23) (Englisch)

771629

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

1. Insert from outside the room cable into left side of the wall

hole, in which the pipe has already existed.

2. Pull out the cable on the front side, and connect the cable

making a loop.

outdoor units carefully. If wiring is not correct, proper operation can not

Insert the cable from the back side of the unit, then pull it out on the front side.

Loosen the screws and insert the cable ends fully into terminal block, then

tighten the screws.

Pull the cable slightly to make sure the cables have been properly inserted and

tightened.

After the cable connection, never fail to fasten the connected cable with the

wiring cover.

When connecting the cable after installing the indoor unit

When connecting the cable before installing the indoor unit

Note:

1. If the supply cord is damaged, it must be replaced by the manufacturer or its

H05RN-F or H07RN-F.

2. If the fuse on PC board is broken please change it with the type of

3. The wiring method should be in line with the local wiring standard.

4. After installation, the power plug should be easily reached.

all-pole switch and the distance between its two contacts should be not less

than 3mm.

T.3.15A/250VAC (Indoor).

To Outdoor unit

Connecting wiring

4G1.0mm

C od e

indic ation Trouble description Analyze and dia gnose

E14

H ea t-exc ha ng e

sensor failure

Ind oor E E P R O M

error

C om m u nica tion

fau lt be tw een

indoor and outdoor

units

Indoor fan m otor

m alfunctio n

O pe ration halt due to breaking

of wire inside the fan m otor;

O pe ration halt due to breaking

of the fan m oto r lead w ires;

D etection error due to fau lty

ind oo r un it P C B ;

Indoor u nit- outdo or unit signal

tra ns m iss io n e rro r du e to w iring

error;

F au lty P C B ;

F au lty E E PR O M d ata ;

F au lty E E P R O M ;

F au lty P C B ;

Fa ulty connector conne ction;

Fa ulty therm istor;

F au lty P C B ;

Room temperature

sensor failure

The power source must be exclusively used for air conditioner.

In the case of installing an air conditioner in a moist place, please install

an ea

For installation in other places, use a circuit breaker as far as possible.

Pipe cutting is carried out with a pipe cutter and burs must be removed.

Power Source Installation

Cutting and Flaring Work of Piping

Clutch-type clutch-type(Rigid-type) Wing-nut type (Imperial-type)

A 0~0.5mm 1.0~1.5mm 1.5~2.0mm

rth leakage breaker.

Lean

tcerrocnItcerroC

On Drainage

It becomes

high midway. The gap with the

ground is too small.

There is the bad

smell from a ditch

It waves.

The end is imm-

ersed in water.

Please install the drain hose so as to be downward slope without fail.

Please don’t do the drainage as shown below.

Please pour water in the drain pan of the indoor unit, and

is carried out surely to outdoor.

In case that the attached drain hose is in a room, please apply heat

insulation to

Less than

5cm

drainage

it without fail.

Crack

Indoor unit

Check Items for Test Run

Gas leak from pipe connecting?

Heat insulation of pipe connecting?

Is drainage securely carried out?

Is the earth line securely connected?

Is power source voltage abided by the code?

Is there any noise?

Is the lamp normally lighting?

Are cooling and heating (when in heat pump) performed normally?

Is the operation of room temperature regulator normal?

Please kindly explain to our customers how to

operate through the instruction manual.

inserted to the terminal block?

Put check mark in boxes

Flare tooling die 1.Cut pipe 2.Remove burs

4.Flare pipe

On Drainage

Check for Installation and Test Run

AS25S2SJ1FA-3

AS35S2SJ1FA-3

AS50S2SJ1FA-3

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Haier Jade Supermatch Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info