Bedienungsanleitung Hama 62727 - WLAN Modem Router ADSL2 plus (Seite 22 von 52) (Deutsch, Englisch, Holländisch, Französisch)

607695

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

8.1 ACL: (Access control for certain services)

In the Main Menu, select the

Access Management menu

item, and then the ACL sub-

item.

The Access Control List (ACL)

allows you to specify exactly

which computers are allowed

to access which service.

ACL: Activated means that the ACL is switched on.

Deactivated means that the ACL is switched off.

ACL Rule Index: You can choose from 1 to 16, which means that you can conﬁgure up to 16 different ACLs.

Active: Yes means that Rule 1, for example, is switched on.

No means that Rule 1, for example, is switched off. You can also switch individual rules on or

off if required.

Secure IP Address: In this ﬁ eld, enter the computer’s IP address if you want the rule to be valid for this computer

exclusively. If you want the rule to be valid for all computers connected to the router, enter

0.0.0.0.

Application: Enter the protocol/application to which the rule should apply. You can choose from the

following options: Web, FTP, Telnet, SNMP, Ping or ALL.

Interface: Select the exchange point for which the rule is valid. You can choose from the following

options: WAN, LAN and Both.

Click SAVE at the bottom of the window to save your settings.

8.2 IP ﬁ lter (access control using IP address)

In the Main Menu, select the Access Management menu item, and then the IP Filter sub-item.

A packet ﬁ lter is an application for

ﬁ ltering the incoming and outgoing data

trafﬁ c in a computer network. This is

generally used to protect the network

from attackers, however the ﬁ lter also

protects against unwanted outgoing

packets. This means, for example, that

you can prevent your own computer from

spreading unwanted and undetected

viruses on the Internet.

IP Filter Set Index: You can save up to 12

settings.

Interface: Use the same setting

as entered in the

Virtual Circuit ﬁ eld

on the Interface

Setup as entered on

the Interface Setup/

LAN/Virtual Circuit

page.

Direction: Incoming: Incoming

packets are ﬁ ltered

Outgoing: Outgoing

packets are ﬁ ltered

Both: Incoming and Outgoing packets are ﬁ ltered (checked) using the preset rule.

IP Rule Index: You can set 1 to 6 rules

Active: Yes means that the rule is switched on. No means that the rule is switched off.

You can also switch individual rules on or off if required.

Source IP Add: IP address of the source computer. If you enter 0.0.0.0 this setting is ignored.

Subnet Mask: Subnet mask of the source computer.

Port: Enter the number of the port to which the rule is to apply. If you enter 0, this setting is ignored.

Destination IP Add: IP address of the “destination” computer. If you enter 0.0.0.0 this setting is ignored.

Subnet Mask: Subnet mask of the “destination” computer.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hama 62727 - WLAN Modem Router ADSL2 plus Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info