Bedienungsanleitung Hammond XM-2 (Seite 4 von 90) (Englisch)

495079

Zoom out

Zoom in

Vorherige Seite

1/90

Nächste Seite

*#1 :/Owner’s Manual

IMPORTANT - PLEASE READ

Power Supply

 Do not use this unit on the same power circuit with any device that

will generate line noise (such as an electric motor or variable light-

ing system).

 The AC adaptor will begin to generate heat after long hours of con-

secutive use. This is normal, and is not a cause for concern.

 Before connecting this unit to other devices, turn off the power to

all units. This will help prevent malfunctions and/or damage to speak-

ers or other devices.

Placement

 Using the unit near power amplifiers (or other equipment contain-

ing large power transformers) may induce hum. To alleviate the prob-

lem, change the orientation of this unit; or move it farther away

from the source of interference.

 This device may interfere with radio and television reception. Do

not use this device in the vicinity of such receivers.

 Noise may be produced if wireless communications devices, such

as cell phones, are operated in the vicinity of this unit. Such noise

could occur when receiving or initiating a call, or while conversing.

Should you experience such problems, you should relocate such

wireless devices so they are at a greater distance from this unit, or

switch them off.

 Do not expose the unit to direct sunlight, place it near devices that

radiate heat, leave it inside an enclosed vehicle, or otherwise sub-

ject it to temperature extremes. Also, do not allow lighting devices

that normally are used while their light source is very close to the

unit (such as a piano light), or powerful spotlights to shine upon the

same area of the unit for extended periods of time. Excessive heat

can deform or discolor the unit.

 When moved from one location to another where the temperature

and/or humidity is very different, water droplets (condensation) may

form inside the unit. Damage or malfunction may result if you at-

tempt to use the unit in this condition. Therefore, before using the

unit, you must allow it to stand for several hours, until the conden-

sation has completely evaporated.

 Do not allow rubber, vinyl, or similar materials to remain on the

unit for long periods of time. Such objects can discolor or other-

wise harmfully affect the finish

 Do not paste stickers, decals, or the like to this instrument. Peeling

such matter off the instrument may damage the exterior finish.

Maintenance

 To clean the unit, use a dry, soft cloth; or one that is slightly damp-

ened.

 To remove stubborn dirt off plastic parts, use a cloth impregnated

with a mild, non-abrasive detergent. Afterwards, be sure to wipe

the unit thoroughly with a soft, dry cloth. Try to wipe the entire

surface using an equal amount of strength, moving the cloth along

with the grain of the wood. Rubbing too hard in the same area can

damage the finish.

 Never use benzine, thinners, alcohol or solvents of any kind, to avoid

the possibility of discoloration and/or deformation.

Additional Precautions

 Please be aware that the contents of memory can be irretrievably

lost as a result of a malfunction, or the improper operation of the

unit. To protect yourself against the risk of losing important data,

we recommend that you periodically save a backup copy of impor-

tant data you have stored in the unit’s memory in another MIDI

device (e.g., a sequencer).

 Unfortunately, it may be impossible to restore the contents of data

that was stored in another MIDI device (e.g., a sequencer) once it

has been lost. Hammond assumes no liability concerning such loss

of data.

 Use a reasonable amount of care when using the unit’s buttons, slid-

ers, or other controls; and when using its jacks and connectors. Rough

handling can lead to malfunctions.

 When connecting / disconnecting all cables, grasp the connector

itself - never pull on the cable. This way you will avoid causing

shorts, or damage to the cable’s internal elements.

 To avoid disturbing your neighbors, try to keep the unit's volume at

reasonable levels. You may prefer to use headphones, so you do not

need to be concerned about those around you (especially when it is

late at night).

 When you need to transport the unit, package it in the box (includ-

ing padding) that it came in, if possible. Otherwise, you will need to

use equivalent packaging materials.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hammond XM-2 Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info