Bedienungsanleitung Hanseatic HGS 8555A3I (Seite 50 von 60) (Deutsch, Englisch)

713572

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Start-upPage GB-20

– The appliance must only be placed on a

level and firm surface. The surface must be

strong enough to support the appliance’s

weight when fully laden.

– Suitable locations are dry, well-ventilated

areas that are cool if possible.

– Unsuitable locations are ones with direct

sunlight or which are directly next to an

oven, hob or radiator.

– The following minimum distances must be

maintained:

– from electrical hobs 3 cm

– from oil and coal burning stoves 30cm

– from other cooling appliances 2 cm

– from washing machines/

dishwashers 2 cm

– If you would like to reduce these distances,

you can fit an insulation plate between the

appliances.

– If underfloor heating is installed at the set-

up location, place the cooling appliance on

an insulation plate made from solid material.

Setting up and aligning the

appliance

1. Place the appliance on as flat and as firm

a base as possible.

2. To ensure adequate air circulation,

– the entire space above the appliance

must be clear.

– the appliance should not stand directly

against the wall (leave a minimum dis-

tance of 5 cm),

– the clearance from the air vents to the

wall, to cabinets or to other devices must

be at least 15 cm.

3. Check the position with a spirit level.

4. Level out any unevenness on the ground

using both of the front screw feet.

– Close the door.

– Tilt the appliance backwards slightly and

screw/unscrew the screw feet.

– Stand the appliance back up again and

check the alignment with a spirit level.

Repeat the process until the appliance

is standing up vertically. The appliance

should not move when opening the door.

Cleaning before use

In order to remove the odour which is pres-

ent with all new appliances, wipe the interior

space and the freezer baskets (2) prior to first

use with a water and vinegar solution. Then

wipe it out with clean water and dry all of the

parts off afterwards.

Connecting the appliance to

electricity

WARNING

Risk of electric shock!

Touching live parts may result in severe

injury or death.

■ Do not operate or continue to oper-

ate the appliance if

– it shows visible signs of damage,

e.g. the power cord is defective,

– it starts smoking or there is a smell

of burning,

– it makes unfamiliar noises.

In such cases, remove the mains plug

from the socket or unscrew/isolate

the fuse and contact our service de-

partment (see page GB-26).

■ It is not permitted to connect the ap-

pliance to a timer or separate remote

control system for the purposes of re-

motely monitoring and controlling.

■ If the mains plug is no longer acces-

sible after installation, an all-pole dis-

connecting device complying with

overvoltage category III must be

connected to the house wiring with a

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hanseatic HGS 8555A3I Seite 50

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info