General
The Screamin’ Eagle FLHT 6-Speed Transmission kit fits
2002 and later Harley-Davidson
®
Touring model
motorcycles.
Kit No. Description
33136-04 Silver
33137-04 Black
An additional kit for the side cover will be required. The kit
number depends on if the motorcycle is using the existing
clutch cable or is being converted to a hydraulically actuated
clutch.
Kit No. Description
38752-04 SE 6-Speed Cable Clutch Side
Cover and Release Pushrod Kit
45033-03A Hydraulic Clutch Kit - black
45383-03A Hydraulic Clutch Kit - chrome
38753-04 SE 6-Speed Hydraulic Side Cover
& Release Kit
See the Service Parts illustration for a list of service parts in
this kit.
Required Service Parts and Tools
Installation of this kit will require additional service parts and
supplies. Specialized tools will include Hose Clamp Pliers
(HD-41137) and Hose Clamp Pliers (HD-97087-65B).
The rider's safety depends upon the correct installation
of this kit. If the procedure is not within your capabilities
or you do not have the correct tools, have your Harley-
Davidson dealer perform the installation. Improper
installation of this kit could result in death or serious
injury. (00308a)
NOTE
This instruction sheet references Service Manual instruc-
tions. A Service Manual for your model motorcycle is avail-
able from any Harley-Davidson dealer.
Installation
Prepare the Motorcycle for Service
1. Mount the motorcycle on a suitable lift.
2. Follow Service Manual instructions given to remove the
seat.
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect battery cables
(negative (–) cable first) before proceeding. (00307a)
Disconnect negative (–) battery cable first. If positive (+)
cable should contact ground with negative (–) cable con-
nected, the resulting sparks can cause a battery explosion,
which could result in death or serious injury. (00049a)
3. Disconnect the battery cables, negative (-) cable first:
a. Remove bolt and negative (–) cable.
b. Remove bolt and positive (+) cable.
Access the 5-Speed Transmission
1. Place a container under the engine, remove the engine
and transmission lubricant drain plugs to drain engine
and transmission fluids.
2. To access the existing 5-speed transmission, follow the
Service Manual instructions in the following sections:
a. SADDLEBAGS, REMOVAL
b. EXHAUST SYSTEM, REMOVAL
NOTE
The right muffler and crossover pipe can be removed in 1
piece and the left muffler and the front and rear header
pipes can be removed in 1 piece. Refer to the Service
Manual Section REMOVING ENGINE FROM CHASSIS for
instructions.
c. REAR WHEEL. REMOVAL
NOTE
Position a jack with a wooden block under the engine and
transmission oil pan to support the weight of the 5-speed
transmission.
d. REAR SWINGARM, REMOVAL
e. STARTER, REMOVAL
f. CLUTCH RELEASE COVER
1WARNING
1WARNING
1WARNING
Gear 5-Speed 6-Speed
1st 3.210 3.210
2nd 2.109 2.209
3rd 1.572 1.572
4th 1.226 1.226
5th 1.000 1.000
6th NA 0.885
INSTRUCTIONS
-J03322
REV. 02-11-2005
SCREAMIN’ EAGLE
®
FLHT 6-SPEED TRANSMISSION
