14 INSTALLATION AND CONNECTIONS
4. Connect the left/right analog audio outputs of a
DVD or laser disc player to the
DVD Audio Inputs
c. Connect the composite video output of your
DVD player to the
DVD Video Input c or the DVD
player’s S-Video output to the
DVD S-Video Input
fl.However, if your DVD player and video display
both support component video, you should make
that connection directly.
When a digital audio connection is used for your
DVD player, the default connection is the
Coaxial
Digital Input 1 Jack
ª. However, the connection
may also be made to any of the
Optical •* or
Coaxial ª( Digital Inputs, provided that the
digital input source selection is changed as shown on
page 23.
For DVD players with DVD-Audio or SACD playback
capability, connect the 6-channel line-level audio out-
puts to the
6-Channel Direct Inputs a. When you
wish to hear the DVD-Audio or SACD playback, first
select the DVD Input on the AVR in order to select the
video signal from the DVD player, then select the 6-
Channel Direct Input source for the audio.
5. Connect the digital audio outputs of a DVD player,
satellite receiver, cable box or HDTV converter to the
appropriate
Optical or Coaxial Digital Inputs
•ª*(.
6. Connect the
Video Monitor Output fib jacks
on the receiver to the composite or S-Video input of
your television monitor or video projector.
VIDEO CONNECTION NOTE:
• Composite and S-Video signals may only be viewed
in their native formats. The AVR 130 will not convert
signals from composite to S-Video, or vice versa.
S-Video inputs may only be viewed when the
AVR 130 is connected to a TV set or video display
with S-Video capability. If you use both standard
composite video and S-Video sources in your
system, it is important that you connect both an
S-Video cable and a standard composite video
cable (a coax cable with an RCA plug on both
ends) between the AVR 130 and your TV or projec-
tor. When it is necessary to make both types of
connections to your TV set, use different inputs if
possible. Consult the instructions for your TV set or
projector for more information on connecting both
types of signals.
Power Connections
This unit is equipped with two accessory AC outlets.
They may be used to power accessory devices, but
they should not be used with high-current draw equip-
ment such as power amplifiers. The total power draw
to each outlet may not exceed 100 watts.
The
Switched AC Accessory Outlet ⁄ will receive
power only when the unit is on. This is recommended
for devices that have no power switch or a mechanical
power switch that may be left in the “ON” position.
NOTE: Many audio and video products go into a
Standby mode when they are used with switched out-
lets, and cannot be fully turned on using the outlet
alone without a remote control command.
The
Unswitched AC Accessory Outlet ¤ will
receive power as long as the unit is plugged into a
powered AC outlet.
Finally, when all connections are complete, plug the
Power Cord ‚ into a non-switched 120-volt AC wall
outlet. You’re almost ready to enjoy the AVR 130!
INSTALLATION AND CONNECTIONS
