switch should be pressed until it pops out from the
front panel and the word “OFF”is seen at the top of
the switch.
NOTE: This switch is normally left in the “ON”position.
2Power Indicator:This LED lights amber when the
unit is in the Standby mode to signal that the AVR is
ready to be turned on.When the unit is in operation,
the indicator is blue
.
3Standby/On Switch:When the Main Power
Switch
1
is “ON,”press this button to turn on the
A
VR 340;press it again to turn the unit off.The
P
ower
Indicator
2
turns blue when the unit is on.
4Headphone Jack: This jack may be used to listen
to the AVR 340’s output through a pair of headphones.
The speakers will automatically be tur
ned off when the
headphone jack is in use.When configuring your sys-
tem using EzSet/EQ,
the calibration microphone should
be plugged into this jack using the supplied adaptor
that converts the small mini-plug at the end of the
microphone’s cord to a 1/4" plug.
5Tone Mode: This button controls the tone mode
settings,enabling adjustment of the bass and treble
boost/cut.You may also use it to take the tone con-
trols out of the signal path completely for
“flat”
response.The first press of the button displays a
TONEINmessage in the Lower Display Line
ıand in the on-screen display.To take the controls
out of the signal path,
press either of the
‹
‹
/
›
›
Buttons )until the display reads TONEOUT.
To change the bass or treble settings,make sure that
TONE
IN
appears in the Lo
wer Display Line
ı
or press either of the
‹
‹
/
›
›
Buttons )until it does.
Press the Tone Mode Button 5until the desired
option of
TREBLEMODEor BASSMODE
appears in the Lo
wer Display Line
ıand in the
on-screen display and then press either of the
‹
‹
/
›
›
Buttons )to enter the desired boost or cut setting.
Both treble and bass contours may be boosted or
cut by up to + or –10dB in increments of 2dB.
See pages 23 and 34 for more information on the
tone controls
.
NOTE
:
The
A
VR 340 is not equipped with a traditional
Balance control.When listening to two-channel materi-
als,if you wish to adjust the stereo image, you may
use the
Channel Adjust Selector to increase or
decrease the level of the left front channel by up to +
or –10dB, and then to decrease or increase the right
front channel by the corresponding amount.However,
when listening to surround materials and most two-
channel materials,it is recommended that you leave
these settings at the results obtained during the config
-
uration process described on pages 19 through 33.
1Main Power Switch
2Power Indicator
3Standby/On Switch
4Headphone Jack
5Tone Mode
6Speaker Selector
7Surround Mode Group Selector
8Surround Mode Selector
9Tuning Selector
)
‹/›
Buttons
!Tuner Band Selector
@Set Button
#Digital Input Selector
$Preset Station Selector
%Delay Adjust Selector
^Input Source Selector
&Tuner Mode Selector
*Optical 4 Digital Audio Input
(Coaxial 4 Digital Audio Input
ÓVideo 4 Video Input Jacks
ÔVideo 4 Audio Input Jacks
Channel Adjust Selector
ÒVolume Control
ÚInput Indicators
ÛSpeaker/Channel Input Indicators
ÙUpper Display Line
ıLower Display Line
ˆSurround Mode Indicators
˜Remote Sensor Window
DIGITALLOGIC 7
VID 1
DVD
CD
FMAM
TAPE
6 8 CH
VID 2
VID 3
VID 4
PRO LOGIC
3 STEREO
H
EADPHONE
DSP
5 7 CH. STEREO
SURR. OFF
1
2
6
7
#
Ú
(
*
Û
8
)
!
@
)
&
%
3
4
˜
5
9
$
^
Ò
Ó
A
VR 340
ˆ
Ù
Ô
ı
O
ptical 4
Coaxial 4
V
ideo 4
FRONT-PANEL CONTROLS
FRONT-PANEL CONTROLS 55
NOTE: To make it easier to follow the instructions that refer to this illustration,a larger copy may be downloaded from the Product Support section for this product
Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.
Art des Missbrauchs:
Forenregeln
Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:
Lesen Sie zuerst die Anleitung;
Schauen Sie nach, ob die Frage bereits gestellt wurde;
Stellen Sie die Frage so deutlich wie nur einigermaßen möglich;
Erwähnen Sie was Sie bereits versucht haben um das Problem zu lösen;
Ist Ihr Problem von einem Besucher gelöst dann lassen Sie ihn / sie wissen in diesem Forum;
Falls Sie reagieren möchten, so verwenden Sie bitte das Antworten- Formular;
Da ihre Frage für alle Besucher sichtbar ist, sollten Sie lieber keine persönliche Daten erwähnen.
Neu registrieren
Registrieren auf E - Mails für Harman Kardon AVR340 wenn:
neue Frage gestellt werden
neue Handbücher vorhanden sind
Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.
Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.
Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.
Ihre Frage wurde zu diesem Forum hinzugefügt
Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.